Help... Truck turns over but wont start

Kybol

New member
My ty has been sitting for about a month, and I went to go start it but it just turns over. Anyone have any ideas off the top of their head? Could it e the fuel pump, how to I test it? Maybe tomorrow I will have some time to look at it, since I am on my way out now. I will check back for any ideas.

Thanks
 

SYO237

SyTy Registry
Re: Help... Truck turns over but wont start

Do you have a FP guage?

When you turn the ignition key to the on position (not starting it) do you hear the pump start to prime?

Checked your ignition plug wire?
 

Don W.

Stab it and steer it
Re: Help... Truck turns over but wont start

As mentioned the FP runs for (2 seconds I think) with key on. Check for fuel pressure at the test fitting, front, left side fuel rail. Also disconnect the coil wire from the cap and insert a plug. Make sure it's grounded and crank to see if you have spark, KEEP IT AWAY FROM THE FUEL YOU JUST, HOPEFULLY, SPILLED.:cool:
 

Kybol

New member
Re: Help... Truck turns over but wont start

I got home today and thought I would try and start it again. I listened for the FP to prime, it did, but it sounded like it "bogged" for a sec then took off. Definatetly not like it used to sound, and for some reason I dont think it primed at all when I first tried and made this thread.
So I will be changing the pump and hopefully thie is the reason my truck was acting up all along. So I should probably just go with the walbro, right? Is this a big job to change? Just drop the tank and pop it out the top like any other truck??

Thanks guys
 

Kybol

New member
Re: Help... Truck turns over but wont start

yeah, we did one not to long ago on one of our farm truck, had to break the lines because of that, and it costed like 5 or 6 hundred to replace it. But it doesnt look like I have any rust under there, so that should make it easier.

Best place to get the kit?
 

CAMSTY

SyTy Obsessed
Re: Help... Truck turns over but wont start

Check with Mark or Nolan to see if they have one in stock or can get you one. 452-3535
 

Don W.

Stab it and steer it
Re: Help... Truck turns over but wont start

Damn near said don't drop the tank just tilt the bed...:rotf:
 

SY2932

Administrator
Re: Help... Truck turns over but wont start

The very first thing to check on these trucks if there is a fuel delivery problem is the ECMB fuse under the dash by the steering wheel. However, since your pump seems to be priming when you turn the ignition to the "ON" position, the fuse is good. This is how you can set and check the fuel pressure with the truck not running:
IMG_0846.sized.jpg

"Applying 12 volts to fuel pump test connector to troubleshoot fuel pump or set fuel pressure with vacuum line still connected and motor off (note fuse for safety)."

If you have both fuel pressure and spark, the ignition module is dead. A bad ignition module won't generate a reference pulse preventing the injectors from firing. Part number is 1048-2827 (it is located under your distributor cap, BTW).
 

supersports10

New member
Re: Help... Truck turns over but wont start

ignition module in the bottom of the distributior. this is your problem.

prone to going out, doesnt like heat, just replaced mine on the jimmy, 6 min and wola!!!!

truck starts and runs.

SS:tup:
 

Kybol

New member
Re: Help... Truck turns over but wont start

I changed the module not to long ago, when problem first started, and it didn't help.
 

SY2932

Administrator
Re: Help... Truck turns over but wont start

Have you connected a fuel pressure gauge to the fuel rail and confirmed fuel pressure yet?
 

Kybol

New member
Re: Help... Truck turns over but wont start

Not yet, I ordered the kit to hook up my guage, so I will post when I install it and see what I find.
 
Top