Electric fan killing the engine.

wheels

Donating Member
I intsalled a Volvo fan, and wired it like so, with the Imperial Fan Control. Only thing different it the size of the relay, i could find a 75 amp, so i went smaller. And no diode between the fan motor wires.

schematic.gif


But when it kicks on, it shuts down the truck unless I give it gas. What should i look for?
 

dgoodhue

BuSTeD 4.3
Re: Electric fan killing the engine.

Mine did that as well, I changed my settings in my chip to compensate for it turning on.
 

TYTILIDIE

METH HEAD
Re: Electric fan killing the engine.

I have the same problem so I leave it on all the time.

Dave, how does that work if you dont mind me asking?
 

dgoodhue

BuSTeD 4.3
Re: Electric fan killing the engine.

I can't remember everything I played with, in summary some of the fan setting (Mainly adding IAC steps, Idle speed) with the fans on. I had some sucess, but still some stumble (it doesn stall out like it did when I first add the fan) I think SyTyGuy mentioned he used the idle vs battery voltage with some good luck.(I did not use that yet)
 

sytyguy

Moderated User
Re: Electric fan killing the engine.

Yeah.....work on the VOLTAGE vs IDLE RPM table (it's a 2D map that lets you dial in more idle rpm when voltage drops (clarity is 1 - 1.5 volt increments IIRC).) Scale more idle in for lower voltage ranges and (with some work) you can get an almost seamless transition when you have a noticeable drop in voltage. Leave the 14v value alone and you're normal idle should remain unaffected. I have a dual 12" fan setup on my truck and when they're activated, you can't even tell....the ecm picks it right up. Before, it would stumble significantly.

No need to monkey up other values/tables when this table directly address the issue. If you have a drop at WOT or other, this table will render no effect, since it only applies to idle rpm command.

Hood
 
Top