Re: Typhoon II #735...Cage Assembly...New Pics!!!
Re: Typhoon II #735...Cage Assembly...New Pics!!!
wantingasy said:
We don't get to see anymore progress? :rant:
Finishing up to cage...and attaching the electronic's brackets.
Door bars and window net...
Bracket for seat back support...it is adjustable and removable. Bracket can be removed and replaced, with another bracket if the current seat was to be replaced with a Kirky alumimun seat...without having to repaint the cross bar.
Chute release lever mounted to the halo crossbar...
Cage dash bar frame for mounting electronic's...Shown here with anti-vibration rubber mounts for the aluminum mounting plate.
With aliminum plate installed....
FXI box and fuse panel mounted to plate...
Plate and electronic's installed on bracket...removing four nuts will allow the bracket to come out for easy access for initial wiring and future service.
The fuse panel is easily accessible from under dash because of the bracket/plate angle.
Full view, behind dash pic...
View with mockup dash in place...electronic's are hidden from eye sight.
A separate bracket was attached to the bar for the coil. This is also rubber mounted for anti-vibration. A bulkhead coil wire connector is used for passage through the firewall.
The Ditigal 7 in mounted on a flat area of the firewall and will somewhat exposed just in front of the center counsole. This is needed to gain access for adjustments that are built into the side of the box. The flat spot was created back when the firewall was shaved and trans hump modified to center the driveline...(it was moved an inch towards the driver's side.)
Some misc pics showing the mounting of the dry sump oil pump and the alternator...
That's all for now...
John