Brake Lights Stay Lit - Help

Richard Le

New member
My battery was low, so I hooked up an AC charger to the battery in an attempt to recharge it. As soon as I connected the charger to the electrical outlet, my underhood light and rear brake lights came on. However, when I removed the charger from the battery and turned off everything, the rear brake lights still stay lit. Any ideas on how to turn them off beside disconnecting the battery? They are on even when the engine is off and the light switch is off.
 

denny

Active member
Re: Brake Lights Stay Lit - Help

Did you try lifting up the brake peddle and see if it goes out.
 

Richard Le

New member
Re: Brake Lights Stay Lit - Help

Sure did. I even drove the truck for about five miles. The brake peddle doesn't seem to have any effect on the brake lights.
 

denny

Active member
Re: Brake Lights Stay Lit - Help

It still could be the brake light switch under the brake pedal is bad.
Maybe someone else will chime in, I am sure they is a way to disconned this switch.

There must also be a fuse for it you can pull until you get it fixed.
 
Last edited:

93 TY 2185

Donating Member
Re: Brake Lights Stay Lit - Help

Richard how are you? Hope all is well. Nice to see you posting again.

Like Doug said get a new brake switch.
 

gjp

another post whore
Re: Brake Lights Stay Lit - Help

switch needs to be pushed all the way in for the light to turn off. Sometimes it moves. Its plastic. You can try to push it toward the firewall. Mine clicked a few times and it has been good ever since.
 

Richard Le

New member
Re: Brake Lights Stay Lit - Help

Thanks guys. I will try to push the switch all the way forward. Today I disconnected the electrical wires to it and twisted it 180-deg, but it didn't want to come out. What's the trick to removing the big white switch assembly should I decide to replace it?
 

cloneman315

Active member
Re: Brake Lights Stay Lit - Help

u shouldnt have power on the white wire till the pedal is pushed and constant on the orange wire at all times check that with a dvom or test light
 

Richard Le

New member
Re: Brake Lights Stay Lit - Help

I replaced the brake switch with a brand new one, but my brake lights still stay on. Would a fried wire cause this? By the way, my hazard flashers stopped working ever since the brake light problem appeared.
 

Daron

Active member
Re: Brake Lights Stay Lit - Help

Weird stuff happens in our trucks when some fuses blow. Have you checked all your fuses?
 

Richard Le

New member
Re: Brake Lights Stay Lit - Help

I checked the fuse to the brake light/hazard flashers, and it was good. I even replaced it with a new one. Haven't checked the rest of the fuses.
 

protosy

New member
Re: Brake Lights Stay Lit - Help

Richard Le said:
I checked the fuse to the brake light/hazard flashers, and it was good. I even replaced it with a new one. Haven't checked the rest of the fuses.

have you tried to manually operate the switch while it is hooked up to the connector? ie- take it off of the braket and press the button on the switch, it should shut off the brake lights. the switch has to be pressed in all the way to shut off the lights, it could just be bad adjustment, even with the new switch.

if thats not it, i would guess there is a fault in steering column. something to do with the turn signal stalk probably.
 

Richard Le

New member
Re: Brake Lights Stay Lit - Help

I finally fixed my brake light problem. I removed the 15-amp fuse for the brake lights, started the engine, inserted the fuse back in, and then depressed the brake pedal several times to reset the brake switch. Now my brake lights function normally as before and go off when I release the brake pedal. Thanks for all the suggestions.
 
Top