3" Turbocharger compressor housing TD06-20G

silverblaz

Member
has anyone used one of these or know if this is a good upgrade ??? i am in the process of getting everything together for my syty engine in my s10 blazer and i have a brand new TD06-20g 14cm.... i saw this while surfing around the net.... input please just wondering waht you guys know about this if its worth it if its a waste of time anything thanks here is the link http://cgi.ebay.com/3-Turbocharger-compressor-housing-TD06-20G-TD05-20G_W0QQitemZ320058340340QQihZ011QQcategoryZ43120QQrdZ1QQssPageNameZWD1VQQcmdZViewItem#ebayphotohosting
 

jbone

Member
Re: 3" Turbocharger compressor housing TD06-20G

I recently put the same turbo in my ty. It pulls a lot harder than stock up high at only 4lbs. of boost. But the lag it creates sucks. I would def. suggest buying a converter too. ill be doing the same shortly. Overall I really like the turbo. But soemthing else to consider is if you are going to b putting in a higher stall canverter, you may want to go with a bigger turbo :D
 

jwaller

Evil Genius/SyTy Guru
Re: 3" Turbocharger compressor housing TD06-20G

if you want a stock turbo upgrade look in my vendor section. you wont need a converter with my setup and it will outperform any 20g no matter what cover you use.
 

Ian Turgeon

Cascading Inspiration
Re: 3" Turbocharger compressor housing TD06-20G

Anyone know if the 3" inlet would do much at all? It'll allow more air to the compressor, but I'm not sure that the inlet size is much of a restriction with the normal 2.5 inlet
 

It's just a six

Super Member
Re: 3" Turbocharger compressor housing TD06-20G

SyTyArchives said:
Anyone know if the 3" inlet would do much at all? It'll allow more air to the compressor, but I'm not sure that the inlet size is much of a restriction with the normal 2.5 inlet

Anytime you can have a bellmouth inlet w/a nice inlet radius, it will improve airflow.
 

It's just a six

Super Member
Re: 3" Turbocharger compressor housing TD06-20G

Also,,,, with the 3" inlet ,it allows you to install a larger than 57 mm compressor wheel.
 

jwaller

Evil Genius/SyTy Guru
Re: 3" Turbocharger compressor housing TD06-20G

It's just a six said:
Also,,,, with the 3" inlet ,it allows you to install a larger than 57 mm compressor wheel.

The limit of the compressor wheel is not the inlet housing. the bearings(non 360deg), turbine housing size(kinda small), and everything is pretty much at it's limit with the 57. the 60-1 could possibly work(not efficient in this application) but anything larger will not because of the id of the comp wheels.
 
Top