hows this for my tranny cooler setup under bed

Ryda85

Senior Member
decided to finally finish my tranny setup.....here is what i am thinking:

out line of tranny -> autometer manifold with sender -> summit remote tranny filter -> BMM-70297 cooler with built in fan that turns on at 160 -> BMM-70266 standard tranny cooler ->back to tranny


all of this would be under the bed, using 6an line and various fittings/adapters...and also plan on adding a new derale tranny pan (increases 2 quarts and has cooling tubes)
 
Last edited:

Ryda85

Senior Member
Re: hows this for my tranny line setup:

Re: hows this for my tranny line setup:

i want to place an order soon guys......do you think this is a little OD? i would think the more cooling the better. i figure 2 coolers, one with a fan, a remote filter, bigger pan and extra line should add about 3 qts to the system does this seem like a bad idea?
 

Ryda85

Senior Member
Re: hows this for my tranny line setup:

Re: hows this for my tranny line setup:

is anyone else only running 1 cooler in the rear?
 

MRKING

New Parts for Old Trucks
Re: hows this for my tranny cooler setup under bed

I have a similar setup . 6 -an line from tranny to temp gauge housing , to 2 coolers , to filter and back to tranny . All on the front end . I worry about under the bed even though it has been done successfully many times .
 

George Blake

DONATING MEMBER
Re: hows this for my tranny cooler setup under bed

Do NOT put it anywhere over the rear axle. Anywhere over the axle. Keep the wiring AWAY from the exhaust. I've seen bad things happen because of those two reasons.
 

SY2455

70's Veteran
Re: hows this for my tranny cooler setup under bed

I just used a remote filter, the 1 BM cooler with the fan on the front end and this was plenty as the fan only comes on during really hot days for a little bit. If I was to change anything, I would just add a deeper trans pan.
 
Top