Oil pressure guage is pinned.

Syclone #1721

I LOVE 4UM SUPERSTARS
I just recently purchased my SY and the Oil pressure guage is pinned all the time. Ignition off and on. Im thinking the guage is bad. I havent gotten a chance to look at it just yet as I have been busy with the holidays but was wondering if this happened to anyone else?
 

dgoodhue

BuSTeD 4.3
Re: Oil pressure guage is pinned.

The sending unit is probably bad (back of the motor by the distributor. Its a pretty common failure.
 

nick041881

Member
Re: Oil pressure guage is pinned.

dgoodhue is right, the pressure sensor goes bad and causes the gauge to flip around and get stuck on the top pin. replace the pressure sensor and you will be ok. I do not remember if you have to open the gauge cluster to flip the gauge needle back......Anyone remember? I have not had to do this for 5 or so years.
 

syclone3

Member
Re: Oil pressure guage is pinned.

Last truck I bought the gauge is below zero at all times. Key on and it never moves to zero. I changed the sending unit and made sure there was a good connection with the plug. Still nothing. Probably pull the cluster out someday and have it looked at. Hate to disturb it.
 

nick041881

Member
Re: Oil pressure guage is pinned.

I am pretty sure that even after you replace the pressure sender that you still have to break open the gauge cluster and reset the needle as it flips all the way around.
 

ViciousV6

400HP/550FTLB
Re: Oil pressure guage is pinned.

Syclone #1721 said:
Ok so it is a common problem...thanks for the info.

Got a couple good ones if you need! Sell ya one of them!

Shoot me a pm if you need one!

Ralph
 

supersports10

New member
Re: Oil pressure guage is pinned.

your gauge has flipped around, that is all.

open it up flip it back, and cut off a small nail, paint it black, then glue it in on the top of the gauge's travel,.....never have a problem agian!!
 

Daron

Active member
Re: Oil pressure guage is pinned.

Our Typhoon recently did the old oil pressure gauge flippy behind the stopper dealio. Then a week later the alternator went dead/failed. Coincidence?
Up until very recently the oil gauge would operate as normal, but I did notice right before the gauge got stuck on the other side of the pin, that it would hit the pin violently at startup. I knew it was just a matter of time before it got stuck. Damnit...
 
Top