Garage hoist for removing bed?

hatrik8

Donating Member
Has anyone done this? I'd like to just lift my bed up using the garage rafters. What would I need? Would rope and pulleys work in the four corners? Or would I need chains? Any ideas or experience using a method like this?
 

nick041881

Member
Re: Garage hoist for removing bed?

rope on the 4 corners would work. I took my bed off and placed two igloo coolers in the center of it to support it and so that it would not rest on the cladding. The bed is not that heavy. Two of us lifted it off no problem.
 

SY2932

Administrator
Re: Garage hoist for removing bed?

Sure, just be sure that your set up is capable of supporting around 230 pounds and you'll be fine:

uvs030126_002.jpg


uvs030126_003.jpg


Add about 16 pounds if you decide to keep the roll pan in there too ;)...

uvs030126_004.jpg
 

hatrik8

Donating Member
Re: Garage hoist for removing bed?

warmpancakes said:
I used a cherry picker and 2 tie down straps in a x- from tie down to tie down

That's a good idea. I'll probably just take the tailgate off to save a few lbs.
 

Mtn Z

Donating Member
Re: Garage hoist for removing bed?

It's not that heavy, but man is it awkward when you are trying not to break cladding. Damn my little tiny driveway to hell for making stuff difficult to walk around. :rant:
 

Aeroking

e.i.
Re: Garage hoist for removing bed?

Hey Mike,

if you add the weights of all the parts together, then weigh the assembled truck... do they weigh the same??
 

jjorgensen52

NHSTE - I'm the only one!
Re: Garage hoist for removing bed?

I removed mine using an engine hoist to the 4 corners. Just be aware, if you load it too unevenly with the gate off, you can get a fair amount of twist (more of concern to the cladding, it doesn't hurt the bed).
 

syclone0577

Member
Re: Garage hoist for removing bed?

I have removed beds by using 4 ratchet straps its easy and you can walk around to each one and crank it up a bit and then on to the next till it's up where you want it.
 
Top