Need Help setting the Ignition on a desturbed engien

Matarex

Ty 93#1612
Just whanted to hear if there was sombody that could help me!,
Just replaced the Stock heads with a cuble of vortech heads and now im at the ponit where im lost :/ kinda, i need to know if the distributor can adjust it self aslong as it points to cyl. 1 and the is can adjust it self from there? or shall it be 100%TDC? or shall it be adjusted with turning engien? or shall the engien just be set upon TDC and the just turn the distributor twords cyl. 1 where after you durn the engien with the stater og the see with the ignition pistol and that shows/turn´s on TDC? and wich wire from the batteri shall be on the ignitionpole(is there any on that has photos or is there a guide some where in the forum/net or is there sombody whit the skilles that can explanit so I and maby others can be help by it :)

thanks
 

NecroWolf

lost marbles member
Re: Need Help setting the Ignition on a desturbed engien

set the number one on tdc then point the rotor at that cylinder. on mine i needed to check my timing chain so i pulled the cover off and set it that way.
 

KDBL1

New member
Re: Need Help setting the Ignition on a desturbed engien

Remove distrbutor cap and watch the rotor. Use a socket and ratchet to turn engine clock wise until 1 piston comes up on the compression stroke.(easier to do with all spark plugs removed) The rotor should be facing slightly forward (driver side) - this should also be where the # 1 terminal in cap is positioned. If they line up replace spark plugs and it should start.
 
Top