Turbo housing and turbine contact

sy#2921

BAMF
I don't believe this is "normal" what do you guys think? Mind you this turbo has less than 500 miles and maybe 20 hours on it.

DSC00435.jpg


Oh the grey specks are the ceramic coating from the headers that failed as well
 

MikeRenz

not stock
Re: Turbo housing and turbine contact

are the blades actually touching the housing? Or is the rash just from flecks of the cermaic coating being gritted between the blades and housing?
 

sy#2921

BAMF
Re: Turbo housing and turbine contact

There is enough shaft play where the blades can contact the housing. Not only does this shaft move up and down but it will go back and forth as well. Also the shaft does not spin nearly as free as it did when new
 

Loeryder

New member
Re: Turbo housing and turbine contact

Sounds like the turbo needs a rebuild.

The bearings are letting go and if it gets much worse the turbine blades are gonna be shot and the housing could be ruined.
 

sy#2921

BAMF
Re: Turbo housing and turbine contact

I just talked to precision and they confirmed that it sounds like a bearing failure like I thought and possible damage to the turbine itself. Sucks that it is out of the 1yr warranty since it took me too long to get this damn thing installed. However, I am having them check to see if it was caused from the ceramic coating failing and chewing things up. This stuff was good to 2000F and has a 3 year complete warranty, needless to say they were not happy when I gave them a heads up on their coating failing and taking out my turbo.


Also, this might or might not fix the feeling the truck had of a clogged cat. I was really starting to lay into the truck after tons of drivability tuning and getting into boost felt weak! It just didnt pull. There is nothing to the exhaust system other than 3" pipe so there shouldnt be any restriction to be had.
 

Loeryder

New member
Re: Turbo housing and turbine contact

Well if the turbine wheel is wobbling around and making contact with the housing then it could effect spool speeds.

I had a stock turbo that ate parts of the plastic crossover tube and even though the compressor wheel had 4 bent fins and was slightly dragging on teh compressor housing it stil made boost fine, just made noise doing it.
 

sy#2921

BAMF
Re: Turbo housing and turbine contact

The compressor side looked great when I took the cover off. But this turbo never felt like it "spooled". even though it would make boost and lots of it just never pulled.
 
Top