external oilpump for tranny cooling?

bezerk

New member
i was wondering this... if you put to bungs in the oilpan and used an elec oilpump for the circulation. it would be so much easier to do the lines and make it cleaner looking..
bad idea? the ATF fluid is thin as water and with a good oil pump you would be heating up the tranny really fast (good thing) and cool it when it's needen.
 

twin74s

Member
Re: external oilpump for tranny cooling?

Only thing that would worry me is starving the pickup with the cooler picking up out of the pan.
 

George Blake

DONATING MEMBER
Re: external oilpump for tranny cooling?

Just saw this. If you are saying, plug the stock fittings and just run an external pump into and out of the pan, no. You will blow things apart. Those fittings are plumbed into the PUMP of the trans. Get an ATSG and follow the progression of fluid flow before you try anything else you are wanting to do.
If you've already bought an external pump, hook fittings up to the plugs on the transfer case and use it on there to help cool the viscous.
 

bezerk

New member
Re: external oilpump for tranny cooling?

i would have jumped the 2 ports ofcourse. i haven't done this. just something i thought it was cool and easy to do
 

cloneman315

Active member
Re: external oilpump for tranny cooling?

never thought about it on the transfer case,has anyone done this yet?say with a frount mounted cooler maybe?
 

bezerk

New member
Re: external oilpump for tranny cooling?

i don't see the transfercase needs extra cooling, it's bassicly a gear drivin transmission, and the clutch isn't going to create much heat extra.
 

George Blake

DONATING MEMBER
Re: external oilpump for tranny cooling?

Heat is what drives the viscous to go to full "hump". If the viscous gets too hot it welds the individual "fans" together. Some actually pop. There is an air gap left in the viscous fluid chamber for expansion but if it gets too hot, it's still not enough. There are pics of this around the board. So yes. Cooling the viscous would help it out significantly. Burnouts, doughnuts, running without a propshaft and running different diameter tire/wheel sizes front to rear are the most common culprits of the heat generated.

bezerk said:
i don't see the transfercase needs extra cooling, it's bassicly a gear drivin transmission, and the clutch isn't going to create much heat extra.
 
Re: external oilpump for tranny cooling?

I think you'd get more benefit by making a water to tranny fluid heat exhanger. Run a stand alone water system with a pump and a HE up front with a modified tranny pan that water can flow through/around. Maybe use a Derale pan or something.
 

George Blake

DONATING MEMBER
Re: external oilpump for tranny cooling?

vanillagorilla said:
I think you'd get more benefit by making a water to tranny fluid heat exhanger. Run a stand alone water system with a pump and a HE up front with a modified tranny pan that water can flow through/around. Maybe use a Derale pan or something.
The temps are more stable when you do this. It's much more expensive to do though.
Here's the actual device you'd use if you chose this route:
http://www.crracing.com/custom_built/external_heat.shtml

Just FYI. Most know this but it still worth saying, but that's what the stock setup is. It uses the stock radiator to "cool" the trans fluid running through a cooler sitting in the END TANK of the stock radiator. It's very efficient which is why it's so small, but if the engine overheats, so does the trans.
 
Top