hit a bump ty died need help

mthurman04

New member
I recently purchased a 93 ty from the LA area. After a couple of months of driving I was merging onto the freeeway, hit a large pot hole and the Ty died. I pulled over checked all of the battery connections and everything seems fine. I took it to a mechanic and he said it was the fuel pump. After replacing the fuel pump with a unit purchased from syty performance it still will not start. Are there some relays or fuses I should check? He says the wiring is fine coming out of the tank.
 

H-TOWN-TYPHOON

You're killin' me, Smalls
Re: hit a bump ty died need help

when you turn the key on does the fuel pump prime? If not, check ecm b fuse. then start looking for a short to ground
 

Rexxenexx

Active member
Re: hit a bump ty died need help

Isn't their a fuel safety switch in the rear where if their is a big G-load a ball gets knocked out of place which cuts off the power to the pump? That might be it, if so look for a red button thing and push it that should reset it.
 

s_blazin

Donating Member
Re: hit a bump ty died need help

yes i have had a terrible time with my fuel pump randomly not priming/engaging and it new. recheck the pump plug and clean if needed and check the ground for proper connection as well.
each time it happend my buddy at the shop i use for things i can't do would not tell me what he did he would just come over get under the rear and mess with something and it would start right up, but it's been quite an annoyance as it happens often adn i'm hoping he will give out his secret but thats my best guess, is that it's the same problem i have
 

mthurman04

New member
Re: hit a bump ty died need help

The engine will still crank and I believe the check engine light is on when the ign is on. Not sure if it stays on though. I will check the rest of the list and get back to you tomorrow night. I really appreciate the help. The only mechanic that knows the Ty is my GN mechanic and he is almost an hour away.
 

SY2932

Administrator
Re: hit a bump ty died need help

Sounds like your ignition module may have taken a dump. Part number is 1048-2827 (located under your distributor cap, BTW) if that turns out to be the problem.
 

mthurman04

New member
Re: hit a bump ty died need help

I took all the questions to my mechanic and after about an hour he called and said it was a bad fuse. Wouldn't tell me which one though. He's a friend so he didn't charge for replacing the pump or troublshooting. After 5 weeks not sure if it was worth it though. At least its back on the road. Thanks for all the help.
 

SY2932

Administrator
Re: hit a bump ty died need help

The bad fuse would be the "ECMB" then since it provides power to the pump.
 

s_blazin

Donating Member
Re: hit a bump ty died need help

by the way for those of you wondering i had the ignition module go out in my blazer and went to schucks and got a new one with a 5 year warranty for 49.95, now i HAVE replaced it 9 times in the past 3 out of the 5 years but i can pull that damn thing out in about 2 mins or less, and normally it would just crank longer than normal and as the cranking times got longer and longer as the days went by, thats how i knew it was the ignition module going bad so most of the time i would drive down to the auto parts store and change it out in the parking lot before they ever even saw me,....

and yes i used the correct dialectric grease, we up here had a bad string of them for about 2 years, almost every shop in town was going broke from warranty replacing the ignition modules they had sold and put in customer vehicles, mostly because they had to cover the towing and the labor.

but it was GM's as well as aftermarkets, i think china had some rebelling workers or something
 
Top