Recent content by Poconojoe

  1. P

    Tubular control arm group buy

    You might be better finding him on Facebook, since he hasn't been on here for almost 2 years
  2. P

    Looking for AC Lines

    Is the hole in the metal fitting part of the line or in the hose itself? If it's in the metal part of the line, you can TIG weld it shut, if it's in the hose itself, you can cut the old piece of hose off the fittings, and crimp on a new length of hose
  3. P

    Power bleed brakes

    For anyone using a vacuum bleeder, make sure that you remove the bleeders and put grease on the threads, to prevent them from leaking in air, and making it look like, there is still air in the lines
  4. P

    Solution for steering slop?

    Are you sure that your toe in is correct and your drag link is level, you adjust your drag link by moving the idler arm, and retightening it.
  5. P

    Power terminal for fuel pump

    Pin 30 should have 12 volts on it and you jump it to pin 87, then the fuel pump should run
  6. P

    WTB 92 Ty

    Good luck with your new vehicle
  7. P

    Stuck wastegate

    If you can't find one, take it apart, measure the shaft and the hole, then look online, there are various places that sell bushings, like Grainger, and McMaster-Carr
  8. P

    WTB Oil Cooler Bolts

    McMaster-Carr has them
  9. P

    Starter relay

    If you switch to the later perminate magnet starter, you shouldn't need to improve the wiring
  10. P

    R134A conversion...what all parts do you need?

    Freeze 12 is not 134, since it still uses mineral oil, which 134 can't do. They've already phased out 134 in a lot of vehicles already. By the way, after January 1,2024, you can no longer build new devices, that use 134
  11. P

    R134A conversion...what all parts do you need?

    You need to drain the oil out of the system and replace it, including draining the compressor. You should also flush the system out. Why are you changing to 134, since it is also being phased out? Why not just put in a drop in replacement, like Freeze12, where you can just put it in, with no...
  12. P

    Typhoon towing

    Just go to the hardware store and buy solid spacers
  13. P

    Rear disk conversion kit?

    Just go to the yard and unbolt everything from the rear end at the yard and bolt it on the your rear end. You need to get a spacer to bolt between the Blazer brakes setup and your rear end. You can find the spacer on Ebay...
  14. P

    Rear disk conversion kit?

    You're better off using 98 and newer Blazer rear disc brakes. They're using the old style calipers, with the ratcheting E brakes. The newer Blazer setup uses and actual brake drum inside the rotor. They're setup uses a lot of shims to align their metal parts. The Blazer setup uses a single...
Top