Recent content by TurboNeon99RT

  1. T

    TDO6H wheel in a TDO6-8cm Housing? GReddy T-67 question too.

    Sorry, reason is...2.0L...not 4.3L :) So 10cm^2 and bigger, take a while to spool up...especially in a TDO6H-10cm housing.
  2. T

    TDO6H wheel in a TDO6-8cm Housing? GReddy T-67 question too.

    I spoke with a turbo rebuilder at forced performance, and he said he has done it before. My question is, are there any downsides to this? Its a fairly big wheel in a fairly small housing....but I figure it would make a bit more power than the standard SyTy TDO6 hotside. All of this would be...
  3. T

    What turbos are available for bolt-on, same DP and exh. mani

    Just curious if anyone has a compilation of all of the turbo's that can be bolted on...aside from the obvious 31 flavors of the 20G Thanks, Sean
  4. T

    I have a 20G-N w/10cm^2 housing, but want to go 8cm^2, help?

    I emailed ya, but I will post here as well... I believe I have the TDO6H wheel as well (who knows if HRC did anything special to it), I don't see why they would put a TDO6 wheel in a TDO6H housing? Hahn S20G TDO6H20G-TDO5H-10cm^2 Compressor Inducer / Major Diameter: 2.075" / 2.675" Turbine...
  5. T

    I have a 20G-N w/10cm^2 housing, but want to go 8cm^2, help?

    I know I don't have a SyTy vehicle, but I was hoping someone on here could help me out since my turbo is identical to the SyTy bolt-on turbos. I have the HRC 20G-N w/10cm^2 housing http://www.hahnracecraft.com/hahn/parts/s20gn.htm TDO6H20G-TDO6H10CM2 HP Range: 400-550 Max. CFM: 720...
Top