50# flow rates

jwaller

Evil Genius/SyTy Guru
I just had my delphi 50's flowed. these are the ones I bought from PTE. now at 43.5 which is the industry standard for testing (except for ford) they flowed within 4% of each other. tested dynamically average flow was 54.7 lb/hr. max operating pressure on them is around 60psig BC they are ball and seat, so care must be taken not to run too much pressure. :eek: the test was done both static and dynamic and results were the same
 

smeagol

Active member
Who told you 60psi?

I have data here that shows a set of 50s tested to 100psi. They failed at 90psi, up until then they were fine.
 

leroy

Donating Member
I think Mitch Murray had some tested a few years back to 100 psi. Is that the data you're talking about Brian?
 

jwaller

Evil Genius/SyTy Guru
cruzin performance in MI. did all the tests. If I set my FP to 60 and leave the truck the heat soak will lock the injectors. after the FP cycles for a few seconds the fp return to normal and it will crank. this has happened on 3 differnt sets of delphi/RP injectors.
 

smeagol

Active member
Yes Jim, that's the data I'm talking about.

That's retarded John. Describe how they 'lock'.

I've done lots of high pressure stuff with Delphi injectors and no problems.
 

jwaller

Evil Genius/SyTy Guru
with the FP set above 55 or so static. I can shut the truck off and when I come back. after it has sat for 10-15 min the thing would just turn over. I would have to cycle the ign switch several times before it would crank. the cycling of the key seems to get the hot fuel out of the rails and lower the pressure in the system back down to normal levels. I had this problem. chris in savanah had this problem and michael has run into this problem. all with delphi's. it doesn't really bother me anymore BC I dont run that high of a pressure anymore. it WAS a huge problem when I had the delphi 30#er's bc I needed a ton of pressure to get the flow out of them.
 

smeagol

Active member
That doesn't show that they are locking at high pressure. It sounds like a hot restart problem in the calibration, which I have seen in some 50# cals. I believe I've fixed it in the stock motor stuff, but haven't messed with the cam/head calibrations.

Ask Keith about this, few trucks down in FL could not start for the life of them when they were hot. Messed with the cal, all good. Haven't seen this in any trucks myself though.
 

TurboManiacal

Donating Member
smeagol said:
That doesn't show that they are locking at high pressure. It sounds like a hot restart problem in the calibration, which I have seen in some 50# cals. I believe I've fixed it in the stock motor stuff, but haven't messed with the cam/head calibrations.

Ask Keith about this, few trucks down in FL could not start for the life of them when they were hot. Messed with the cal, all good. Haven't seen this in any trucks myself though.

E's was doing this on a cool night in Raliegh in February...I believe he's just chalked it up to ownership at this point...
 

smeagol

Active member
I wish I had more time and a truck local with one of these buildups to do some more work with. The braphoon is the closest we have, and it starts fine. I wish I could do something in the chip to fix the leaky valve seals.
 

E-Rue

New member
yeah hot restart is dificult.
somtimes i have to hold the pedal all the way down to get it to fire again.

e
 
Top