boost control with pitbull chip

msheller

New member
Help me out here...I heard that the boost control on the pitbull chip is better than stock...is that true? Denny Raab used pitbull with stock wg , 20psi, stock turbo and no cat or muff and no boost control issues, ran 12.1's per report...

Can I run an elec exhaust dump+pitbull chip with stk wg/turbo and expect control over boost??

Matt
 

Sy769

Donating Member
Don't think so.

Pitbull chip is a 2 bar chip so the tables won't be fueling for above ~15psi.

You can turn up the fuel pressure and run more boost but you end up being rich at lower boost.

You can somewhat control boost with the stock wastegate and a dump with some work.......however the trucks I have worked on were at around 17psi and only did very well from a stop. Any full throttle downshifting would result it serious spikes. Not good.
My truck has good boost control with a manual controller and open exhaust after the cat. I only get 1-2 psi spike somtimes which doesn't cause any problems because I use a 3 bar cal and alky/water injection.
 

BillC

New member
I believe Denny Raab is now running DFI (or some other aftermarket EFI system), and an external wastegate. He hasn't had the stock turbo on his truck since before I met him, and that was at least 5-6 years ago.

As far as running the stock turbo & wastegate with no cat and no muffler, you won't get good boost control, regardless of what chip you use.

The problem is that the stock wastegate is incapable of flowing enough exhaust to properly control boost without the added backpressure of the stock cat and exhaust. If you remove the restriction without improving the wastegate (either porting it or using an external), you'll get horrendous, uncontrollable boost spikes.

Also, as Patrick said, using a 2-bar chip to run more than 14.5 psi of boost is just asking for trouble.
 
Top