Datamaster pcm cycling

tallcoolone

New member
Well, i have a Datamaster question...When I hit START, "pcm cycling" followed by1,2,3 et cetera appears...when I finish my run, it says that the program ran for 1 sec...therefore data is only one point in time...what am I doing wrong...I have varied the cycling rate from 190 to 200....Any suggestions appreciated
 

myclone

Donating Member
Have you changed the rate in increments of 2 or 1 between 190 and 200? I hadda do it in increments of 1 to hit it. You might have to go further than 190 also. A truck I worked on a while back would only communicate at 187.

HTH
 

Rufus

New member
This could be a noise problem on the ALDL link - aftermarket ignition systems are famous for causing these sorts of problems! Make sure the PCM and engine block grounds are well secured.

Also, are you running a native serial port, or are you going through a USB adaptor? Some USB adapters work, others don't, its a matter of getting the timing just right! Conflicts with IR ports can also cause these sorts of problems.

Gary
 

Rufus

New member
Another thought - have you tried the "Test Com" button? If so, what are the results? You can also look in the _myLog.txt file to see a report of what Datamaster was doing while you were trying to connect. This can help diagnose connect problems

Gary
 
Top