Deciding turbo size?

ZR1 S10

New member
I'm trying to decide what size turbo to get for my setup.

I've got a built 4.3l w/ 8:5.1 compression, edelbrock 2114 w/ mpfi, and a bunch of other stuff including ls1 edit. I'm looking at the ATR turbo headers but I need to decide on what turbo to get. I'd like to make full boost before 3,000rpms and target hp mabye 450-500 at the wheels? Is it possible to get that? I'm not sure what the 4.3's putting out but I'd guess around 220at the wheels n/a.


Thanks! :rock:
 

dgoodhue

BuSTeD 4.3
The Garrett GT-35R turbo will do that, the ball bearings make quick spool up , but it also is more expensive. You could get away with a TE60 or PT54, but they will be a little more laggy.
 

ZR1 S10

New member
Cool thanks! The 3000 spool up is just a target if its after that its fine! I was planning on getting a ballbearing turbo to begin with :D !

Whats your take on the ATR headers? Worth the money or would I be better off with stock manifolds?

GT-35R BB 650 .82, 1.06 $1329 Is that the one your talking about? Also wheres a good place to buy it? Sofar I've found:

http://forcedinductions.com/productsgarrett.htm

What about the GT-30R BB or is that to small?
 

dgoodhue

BuSTeD 4.3
ZR1 S10 said:
Whats your take on the ATR headers? Worth the money or would I be better off with stock manifolds?

You could go with stock manifolds or Headers. Stock manifolds have made that much hp before. It use ot be thought you need headers for than high 11's, but a few done 10's with the stock manifolds. Most of the 10 second and faster trucks have header though. Headers are nice but they make plugs changes harder, they are more prone to burning up spark plugs wires and they add more heat to the engine comparrtment.
 

BigAl...

Member
Zr1 S10, the suggestions already given are very good for your HP requirements, BUT it has been my experience that we ALWAYS want more! I would go with something bigger! Again if you really only want 4-500hp (even 600hp at big boost) then the above mentioned turbo will work great.

just my .02 worth.

BigAl...
 

ZR1 S10

New member
BigAl... said:
Zr1 S10, the suggestions already given are very good for your HP requirements, BUT it has been my experience that we ALWAYS want more! I would go with something bigger! Again if you really only want 4-500hp (even 600hp at big boost) then the above mentioned turbo will work great.

just my .02 worth.

BigAl...

Well I think Im gonna stay at the 500rwhp range. But whats the large turbos you speak of?

Also will ceramic coating help with the ATR headers?

Oh a firend of mine recomended this turbo to me:

60-1 "P" Trim - 630hp

TO4 ' P ' Trim Turbine wheel - 64.5mm / 78mm
Super 70 Compressor wheel - 60.5mm / 84mm
.70a/r Compressor housing

Also said I'd need a T3 turbine inlet. But I dunno if its a ball bearing turbo or what not because it's only $475?
Thanks again for all the help guys!!!! :rock:
 
Top