DIY WB questions

dgoodhue

BuSTeD 4.3
I am little undecided on which WB board I should buy. I am either going to buy the DIY-ECM one list on their site or the Aus Techweasel one with datalogging capabilities. I would prefer to buy the DIY-Ecm one because the DIY WB agreement and price.

I am worried about getting data from the WB though. I plan on using this on 2 vehicles and one (86 Corvette) has been barely tuned at all with tunercat, while my Sy has an ulitimate chip. It appears as though I would have to do some highways run with a companion to get any useful data from the stand alone display. I searched through the forum on WB subject and BG mentioned something about DIG's ability to run this through the his chip. Is this a simple source code change? How would I be able to read this through my Diacom, do I have to change something internal to read this or do I need DM? The AUS 1.5 Version of the board appears to be able to datalog through a laptop. (sounds attractive to me), but its unclear to me what exactly to need to get this operate properly, it mentions it datalog vs RPM, where do I get that from? Do I have to tap my tach wire on the distributor or get data from the ALDL? Does it come with software to datalog the info or do I have to figuire out how to write that software also.
 

myclone

Donating Member
There was a post about using a spare input on the ECM to datalog the WB volts via datamaster. You might check here http://www.chitownsyty.com/html/tech.htm

If its not there its around here somewhere cause Ive seen it but I cant find it now. Seems it mighta been up on BG site or something if its not at the link above.

HTH :-?
 

TheObiJuan

Active member
this help?

leroy said:
Use ecm pin F14. It is the unused fuel pump input. I removed the pin from the egr, and used it, since I have that disabled.

Jim

leroy said:
On 2002-02-21 16:09, TurboTony wrote:
I was under the impression that a person could use the 5 volt input for an a/c pressure signal to datalog the w/b. As I understand it the ecm is equipped with this for the quad 4 application.

Is this what Digs code is for or am I way off base here.

Dig's code uses the 5 volt input on pin F14. It's filtered and then spit out in the commanded AFR field in the ALDL data. You still have to do some math, converting A/D counts to volts and then checking that against the v_out table.

Jim

from
http://www.syty.net/phpBB2/viewtopic.php?t=11037&postdays=0&postorder=asc&highlight=f14&start=15
 

dgoodhue

BuSTeD 4.3
Does anyone have a disassembled and commented $58 code? I was hoping to reverse engineer DIG's WB source code change so I can apply it to my other ECM.
 
Top