Felpro Vortec intake gaskets #

93ty475

Donating Member
a little off topic here :lol: i have one more quick question....will an intake gasket, homemade out of store bought gasket material, work? i have everything here to complete my conversion (heads on and torqued) except the correct intake gasket...as usual, i'm impatient and i want to finish this...i examined a few materials at our local o'reilly's and one even had metal in sandwiched between the typical asbestos stuff...also, how would one go about cutting the material with the metal in it ....i really think i need to make my own custom ones anyway...i read about tony's, but i couldn't picture the material he used...bob? mike? anybody?
 

bigtime

Sy-Ty Builder
I ended up making my own out of a piece of Mr Gasket material. They sell it in sheets about 8X24
 

93ty475

Donating Member
bigtime said:
I ended up making my own out of a piece of Mr Gasket material. They sell it in sheets about 8X24

would it help to spray it with permatex copper? ever had any problems under boost? what color was your raw material?
 

bigtime

Sy-Ty Builder
can't find it on the web. I is in the catalog as My speed shop got it for me. It looks just like there gaskets with the MG logo on it. I will send you the set i have on monday you pay shipping you can have them.
 

bigtime

Sy-Ty Builder
FOUND IT !
jegs
Mr. Gasket Sheet Gasket Material

72077B.gif




View larger image
Product images may differ from actual product appearance.
Mr Gasket's own 1/16'' thick gasket material, that can be used for special applications.



Exhaust Gasket Material
720-5961 Ultra Seal Material, 6'' x 24'' $15.99
720-77A Exhaust Material, 6'' x 24'' | View Product $7.99
Intake Gasket Material
720-77B Intake Material, 12'' x 12'' | View Product $7.99
720-77C Intake Material, 6'' x 24'' | View Product $8.99
 

THEMADTYPH00N

Active member
Hey Bob, arent you using the Edelbrock carb intake? Why did you make your own instead of just using the plastic GM gaskets with the rubber around the edges?
 

bigtime

Sy-Ty Builder
THEMADTYPH00N said:
Hey Bob, arent you using the Edelbrock carb intake? Why did you make your own instead of just using the plastic GM gaskets with the rubber around the edges?

I needed a little thicker than the stock GM's so i had to make 2 sets of the MG ones.
 
Top