Yes - that one will work. Keep in mind it is a 0-125psi regulator, so very small adjustments will give you a lot of boost. I know the regulator setup has been discussed before, but here are some things I have learned if you go this route:
1. Hook it up to your compressor with an inlet pressure around 50psi, then set the regulator for the boost you want to ADD to the system using the gauge for reference. Keep in mind that cheap gauge most likely isn't very accurate, especially at low pressures.
2. Remove the gauge, then back off the regulator 1/2 turn (safety factor).
3. Install it on your truck and test by SLOWLY running up boost in 3rd gear while watching your boost gauge. Never take off in 1st gear after making an adjustment - it will spool too fast.
4. Make regulator adjustments no more than 1/2 turn, preferably 1/4 turn.
You may also consider something like this unit:
http://cgi.ebay.com/ebaymotors/ws/e...3742&item=2473561793&sspagename=STRK:MEBWA:IT
I am not endorsing the brand name or this regulator in general, just the fact that it is a 0-30psi regulator so you could probably make finer adjustments than with the 0-125 psi unit.
