IC pump connector

[Don W.]

Just a little anal here, but I want to take apart the connector (molex?) on the end of the wire from the IC pump in order to use that connector on my Johnson pump. Does that thing come apart? I've got the little retainer off to the side but can't see how to get the wires out. I'd like to do this to avoid just cutting the wires and splicing them to the Johnson wires. Can that connector be purchased a an auto parts store?

Thanks

 

[SYO237]

Re: IC pump connector

Don, if you need, I think i have 3-4 of the connectors laying around (all cut from the harness). I can send you one if you want it.

 

[Sy777]

Re: IC pump connector

Yes they can be purchased from an auto store but they come with wires ready to splice. I know how you fell and trust me after looking at wat the dealer and an auto parts store had, cut it of the old pump and splice it.

 

[Don W.]

Re: IC pump connector

Actually that would work. I was just attempting to not have a splice "out in the open" in that area. I'll send a PM.

 

[jjorgensen52]

Re: IC pump connector

if you're splicing out in the open, do the twist solder methood and then use some adhesive lined shrink wrap. This stuff is amazing, I use it in salt water marine apps and have no trouble at all. Just make sure the wires are clean and oil / goo free before wrapping them.

 

[Don W.]

Re: IC pump connector

I finally found what I needed. The 2 wire Beldon Weather Pack terminal for the IC pump is part number 784522. This is the single pack number for hanging on the carousel's you see on the parts floor. There is a different number for bulk. Trouble is it's bare so you need the terminals that the wire attaches to and the tiny seal that goes in on back side. Those numbers should be 725151 & 725152 you'll need two of each. Little heat shrink tubing on the wires and it looks like factory.:tup: