Low oil pressure question

Damian

Member
Re: Low oil pressure question

Mos new cars come with aluminum bearings anyways, might as well give them a shot.
 
Re: Low oil pressure question

There has been quite a few rebuilds that are loosing bearings. What brand of bearings did you use. Just wondering.

I don't remember which brand since it took several years from the time I rebuilt the block until I got the truck running and on the road. I thought they were Clevite, but I could be wrong. I'll have to go through my stack of receipts. I do know they were not oversized and when I checked clearances with Plastigage everything was well within spec.

I've noticed the same phenomenon. Lots of fresh engines taking out the bearings in 1,000 miles or less. Enough of them that it isn't just bad luck, or crappy install or wrong bearings.

I'm wondering how many of these fresh engines have a non-stock tune that is way too rich? Ie, "safe" (super-duper-AFR <10 rich for "safety") that is diluting the oil, and taking out the bearings.

How many engines with stock PROM's and tunes have lost the bearings in <1,000 miles? I've built 5 stockers. I've lost no bearings.

I think it could be fuel dilution. But what do I know?

It was a stock tune on a stock rebuild (ie cam, intake, injectors etc). The only thing not stock about the bottom end is a gapless second ring set.
 
Top