Missing WB calibration resistor.

Sy769

Donating Member
I did the dumbest thing I think I have ever done. :splat: Decided to use weather pack connectors at the sensor and relocate the calibration resistor.
Finally got around to working on it today as I haven't had time lately. Calibration resistor that I removed from the factory connector is gone. I can't find it anywhere.
I really can't afford another $200 sensor. How can I find out what resistor I need for the sensor to be accurate?
Any ideas or know someone who might know how to establish the correct resistor?

:banghead:
 

leroy

Donating Member
Patrick,

I think you are out of luck, unless you measured the resistance before it was lost. The only other thing you could do is replace it with a pot, and calibrate it against an already working wideband. You could also calibrate it for free air with the pot, but probably less accurate.

Jim
 

kwick6

Donating Member
FWIW, my 13246 bosch sensor has a 7.5K ohm calibration resistor.

just measured it with my fluke meter. HTH.
 
Top