my tuner pro file

cameronsclone

New member
Re: my tuner pro file

heres the link to the file http://www.mediafire.com/?02tydm7tnnp
Thanks for the tip:tup. For anyone who wants to look at these things, check sessions 4 and 8. I may have an exhaust leak, because at full tps i can only hit 13 psi max with minimum knock. ultimate was set at t1-16 the for all the runs. Does anything on there show signs of an exhaust leak? it sure sounds like one when driving, I'll have to check it out tomorrow in the daylight. Thanks in advance.
 

TYTILIDIE

METH HEAD
Re: my tuner pro file

You know, I look at it and see you knocking quite a bit at low boost levels as well. Your o2's look pretty good and timing seems fine. I would check your ignition. Somethign is definately not right. Everything looks like its where it should be and IMO, when everything is where it is supposed to be I tend to think its something mechanical. :2cents:
 
Last edited:

cameronsclone

New member
Re: my tuner pro file

hmmm ok. Is there anything that would point to an exhaust leak or anything? I have this ticking/thudding sound coming from the pass side. I'm pretty sure I need new wires, theyve been on there for like 4 years or more.
 

TYTILIDIE

METH HEAD
Re: my tuner pro file

The ticking could very well be an exhaust leak. The thud I dont know, yould have to decribe it better. The ticking could also be a lifter. Check around the exhaust manifold for black soot and that will tell you if you have an exhaust leak.
 

TYTILIDIE

METH HEAD
Re: my tuner pro file

FWIW, I had an exhaust leak and it didnt really cause any knock, other than what I normally had.
 

cameronsclone

New member
Re: my tuner pro file

Could the knocking be from the drivers side motor mount being broken? I have a tailgate cable as a tiedown, but I need another one because its not very tight.
 

TYTILIDIE

METH HEAD
Re: my tuner pro file

cameronsclone said:
Could the knocking be from the drivers side motor mount being broken? I have a tailgate cable as a tiedown, but I need another one because its not very tight.

Dude, you never want a broken driverside mount. Are you sure its broken? If so, Ild bet that has something to do with it. You can also take a healthy bite into your upper radiator hose that way, twist and crack your heater core lines, bust up your fan shroud, bend your down pipe, etc., etc.. Get that fixed if it is indeed broken.
 

cameronsclone

New member
Re: my tuner pro file

Ok. Are solid mounts the way to go? It's not my daily so I don't think vibration is too much of an issue.
 

TYTILIDIE

METH HEAD
Re: my tuner pro file

cameronsclone said:
Ok. Are solid mounts the way to go? It's not my daily so I don't think vibration is too much of an issue.

Theyre on my list. Stock just dont last. I cant keep one together for more than a week or 2. But I now use a chain so....
 

willyson

trollin'
Re: my tuner pro file

you will feel more engine vibration with solid motor mount, id try a stock with a tiedown before going solid, but then again changing it if it broke again would be a bitch
 
Top