need directions replacing intercooler-TB coupler

Sy1600NVa

New member
Hello,

I know this sounds like a really dumb question but I have the big black intercooler(the one with the groves running along the top). I need to change my coupler but would like a little direction here with it. I searched the forums before posting this request and could not find a thread on my subject. When responding to this please assume you are talking to someone with minimal knowledge of these trucks. Thank you in advance.

Neil
 

MikeRenz

not stock
Re: need directions replacing intercooler-TB coupler

should just be some hose clamps holding it on. Either a flathead screwdriver or a nutdriver will let you remove the clamps, and then remove the coupler. It's extremely straight forward, even if you aren't an ace mechanic.
 

ghettosled

SYTY SUPERSTORE
Re: need directions replacing intercooler-TB coupler

you'll most likely have to loosen up the (3) support brackets underneath the intercooler with a 15mm socket. then the (2) hose clamps. Slide on new coupler, and reverse the process.
 

ghettosled

SYTY SUPERSTORE
Re: need directions replacing intercooler-TB coupler

you'll most likely have to loosen up the (3) support brackets underneath the intercooler with a 15mm socket. then the (2) hose clamps. Slide on new coupler, and reverse the process.
 

Sy1600NVa

New member
Re: need directions replacing intercooler-TB coupler

So I do not have to remove the intercooler or drain anything?
 

Gimpster

Gimp Extraordinaire
Re: need directions replacing intercooler-TB coupler

I've had my IC off its mounts 3 times already since owning the truck, and no draining is required. That being said, my truck had its hard lines to the IC removed so it can move freely around the engine bay.

Do like ghettosled said, loosen the bolts. It should pivot enough to get that out, even if your truck still has the stock IC hard lines I'd think.
 

ghettosled

SYTY SUPERSTORE
Re: need directions replacing intercooler-TB coupler

i'm pretty sure you will have to loosen the hoses on the back if you still have the metal ic lines.. they are bolted to the intake and dont really move much. If you replaced them with rubber (like most do), then you wouldn't have to worry about it leaking. You could place the IC almost anywhere in the engine bay and it wouldnt leak.
 
Top