no start 4.3 cpi???????

crawlinGT

Donating Member
i have my SGT and i replaced the shortblock about 2 months ago and has ran fine for about a month and a half then after a day of driving i go to start it later in the evening it wouldnt start and just kept cranking the next day it started right up after i disconnected the battery for a 5 min or so. i thought the problem was a feul pump because it wouldnt turn on and couldnt hear it like usual. i replaced the feul pump new sending unit new plugs,wires,and feul regulator. im getting spark and there is fuel pressure in the lines. it will crank all day but wont start. any ideas ??????????
 
Re: no start 4.3 cpi???????

I just had to replace the CPI unit in the girlfriends blazer, what you can do to check is pull the plenum off and while you are watching have somone turn the key to the on position, WATCH OUT!!!!! it should pressurize the system and you can see if there are any leaks in the spider, or supply and return lines (my supply line was leaking so bad it would flood the car bad enough that it wouldn't crank anymore) it's probably leaking there. If that's not the case and your sure you have spark and fuel the only thing left is compression, and making sure the spark happens at the right time.
 

crawlinGT

Donating Member
Re: no start 4.3 cpi???????

i replaced those lines and the regulator ive went through all that already, im in a new problem
 

jjorgensen52

NHSTE - I'm the only one!
Re: no start 4.3 cpi???????

Check the MAP sensor. I had one go bad in my Sierra and it cut the fuel to the truck because it seemed to think it was under about 200 psi of boost :roll: ... it appears it was stuck, because I put some pressure on it and then some vacuum and it came free and started to work again. Replaced it anyway and haven't had a trouble since. I had the same no fuel but pressure problem you have
 

syclonekid43

New member
Re: no start 4.3 cpi???????

hows the spark look? dull and dead or nice and bright? might want to have the ing. module tested
 
Re: no start 4.3 cpi???????

well then if your getting spark and fuel the only thing left is compression and spark timing. Make sure your timing is on (line up your crank to TDC and make sure your rotor on your dist is pointing to #1) if that is good then check comp.
 

crawlinGT

Donating Member
Re: no start 4.3 cpi???????

well i think i could be getting better spark so im going to reground my coil and maybe get a new one but i cant really see my spark i can feel it but cant see a nice arc.
 

sleepy

Member
Re: no start 4.3 cpi???????

Also check your ground wire connections - engine to frame - engine to body. These could result in a loss of voltage to the ignition system, thus not enough spark. Also - those cpi's are very reliant on proper fuel pressure - try to check your pressure at the back of the intake where the lines go in (there should be a pressure port there). You want 54-64 lbs of pressure. If it is less than 50, the truck probably won't have enough pressure to start. I know you just put in a new pump, pickup, hopefully filter, but you never know.
Good luck
 
Top