No start - need help

[denny]

The last two weeks I been having trouble getting the ty to start.
It started out as hard start when the truck gets warm then to no start at all.

getting spark at the plugs and getting fuel at the rail
but NO pulse from the ecu. I have a noid light kit.

happens on both the bs3 and the stock ecu - I got the stock ecu on right now wiht a htp chip.

I am guessing it must be some sensor but don't know which one.

I had no start before where the pickup coil was bad , so I just put in in a new reman distributor from autozone.


When i swap the stock ecu it started for a few seconds and dies as i tried to adjust the timing, same thing had happen with the bs3.

Any ideas ?

 

[nr94]

Re: No start - need help

wires to the injectors have a ground wire that might be off or loose.
low voltage in the battery, less than 9 volts on the BS3 will not start.

 

[denny]

Re: No start - need help

Autozone sold me a defect distributor, i exchanged the distributor and it start right up with the new one.

 

[Captain Morgan]

Re: No start - need help

glad to hear you figured it out. I hate defective "new" parts.