Question for the Sy Masters...

SYTurbo

New member
My SY is bone stock. I'm getting a Check Engine Light when I first start my truck. Meanwhile, the stock Vacuum/Turbo gauge stays pegged at zero. The truck drives sluggish, like an old carburated car without a choke, while in this condition. After a few minutes the light goes out and the gauge returns to normal? This usually happens on cold and or damp mornings. My questions are: Has anyone ever had this cold start problems? What could be causing this? Air flow sensor? Intake Manifold Vacuum? What sensors should I be looking at as the cause? Help me out here guys...It's driving me crazy!! Thanks.
 

jwaller

Evil Genius/SyTy Guru
it might be a map sensor....pull the code from the ecm and that will tell you what it is. or go to autozone and they can pull it for you.
 

SYTurbo

New member
Can I pull the code without a scan tool? The problem is intermittent...Would I have to pull the code while the check engine light is on or does it store it?
 

JoeLutz

New member
On 2001-12-05 13:36, SYTurbo wrote:
Can I pull the code without a scan tool? The problem is intermittent...Would I have to pull the code while the check engine light is on or does it store it?
It stores it in memory until you remove the battery cable or restart the vehicle like 20 times or something.
 

just a 6

R.I.P MyClone
I'll check the O2-sensor too

Swede//

On 2001-12-05 09:51, SYTurbo wrote:
My SY is bone stock. I'm getting a Check Engine Light when I first start my truck. Meanwhile, the stock Vacuum/Turbo gauge stays pegged at zero. The truck drives sluggish, like an old carburated car without a choke, while in this condition. After a few minutes the light goes out and the gauge returns to normal? This usually happens on cold and or damp mornings. My questions are: Has anyone ever had this cold start problems? What could be causing this? Air flow sensor? Intake Manifold Vacuum? What sensors should I be looking at as the cause? Help me out here guys...It's driving me crazy!! Thanks.
 
B

Blake

Guest
If you are getting a MAP low voltage code(34 I think), disconnect the MAP sensor from the bracket and unplug the MAP sensor wire harness from the MAP(It is very brittle be careful). Now, take your wire harness and follow it back to where it bends around the "multi-use bracket"(it is called this because it holds the MAP and the EVRV for the EGR valve). Bend the MAP sensor harness the opposite way of natural bend where it is pulled tight around this bracket and look to see if the bracket has cut into the insulation on the wires. If so, tape them up, if they are cut all the way through then solder them back together then tape them up so they are insulated from each other(should be three wires) and put everything back together.You may want to put some of that black corugated wire insulation that is slit down the side(available at Autozone,etc.)over it as well. Clear your codes by pulling the ecmB fuse or disconnecting the battery(you'll lose your stations on your radio of course) and go out driving again to make sure that was the only problem.
I've seen this happen on 3 trucks now.
Blake
 

Buster

New member
My guess would be the vac line going to the map sensor, could have a hugh crack or off completely.
 
Top