using bigger injectors with the Ultimate

BigAl...

Member
I'm not saying this works! but recently I met someone that had put 40# injectors in while using the ultimate, he said all he did was lower the FP. I remember BG mentioning that he picked the 50#'ers because the linearity was similar to the stock injectors. (BG maybe you can shed some light on this) I did not ride in the truck, so I don't know what the drivability is like but he mentioned that "it drives just fine and it hauls ass" I'm not sure what his perception of "drives just fine" is, but it made me wonder "can this work???" BG BG BG BG...

TIA
BigAl...
 

UNIsackV6

Member
Hmmm, I've talked to him about this before and I'm pretty sure you're right he picked the 50's due to their flow characteristics. The 40's seemed to significantly different, not sure what lowering the FP will do except make them act like smaller injectors? Which is what you are trying to get away from. Sounds to me like this guy should put a Scantool on when it is running great to make sure it is running great. It may feel strong for a while but if you have fueling issues and you start raising boost you're asking for trouble.
 

smeagol

Active member
Yup, what's the point of putting 40s in only to have to lower your fuel pressure? 40s at lower fuel pressure will act like smaller injectors. Granted, they may act like 34-36lb if you only lower the fuel pressure a tad, but I'm going to remain skeptical :wink:

It may work, and *could* work fine, but I doubt it. I've heard many definitions of 'running fine'. To some, if it doesn't foul plugs, it is running fine. To others, if you don't have Lexus like idle and 18mpg, it sucks. I'm somewhere in the middle :wink:

Brian G
 
ok, here's a related question - how much leeway is there in the block learn to let the ecu pull pulsewidth back as a "learned" function/adjustment, such that it lets the big injects run happily while not going as close to 100% duty?
i am plaaning on throwing in a set of 36lb ford motorsports i have laying round (10-1 ultimate led in it already). will post results afterwards.
i would be grateful for your thoughts on this brian
thanks
 

smeagol

Active member
The BLM has some good pulling 'power', but the nature of the beast is what is annoying. With most GM cars, you have 15 BLM cells, covering most driving conditions. They can really cover most issues when going to slightly larger injectors. Syty's have 2 BLM cells. So it is difficult to have *any* accuracy when it comes to fueling trims IMO.

The Ford 36s are very linear, one of the few injectors (that is if they are the old blue top Ford injectors). They are your best bet for making larger injectors work. Only real big deal is that they are only 4lb/hr larger than stock. You could try running them on the Ultimate at 43-45psi, and see how the numbers look. I'd be curious to see your results as far as drivability and such.

BG
 

leroy

Donating Member
On a related note, I'm installing some 55# injectors soon. I'll let you know how it goes.

Jim
 

leroy

Donating Member
Yep, injector drivers upgraded. I have a couple of extra drivers, if you know anyone else that wants to try it.

Jim
 
Top