will 1.6roller rocker.

[Quickstop [UK]]

Re: will 1.6roller rocker.

Call arp and tell them what you are doing. They have the 10mm hardened washers you need. They told me to use the chamfered ones. i dont know if thats how you spell it. they said that kept it from possibly breaking off the head of the rocker stud. youll need to use two washers for each stud.

got a part number? the 10mm ones aren't the hardened chrome moly if they are chamfered like you say?

There are various thicknesses as well. I don't want to assume but I am guessing .120 inches thick?

They are going under the Crane Gold Race Rockers that I got from Loeryder on here - self aligning.

 

[Quickstop [UK]]

Re: will 1.6roller rocker.

OK,

thanks for all the info guys. I have been in touch with ARP and ordered some washers.

I spoke to a tech guy and apparently they are discontinuing the chamfered hardened ones but I got some that were left over.

I was given a part number via the online enquiries form : 400 8519. This is the SS chamfered one but the other guy I spoke to said that the hard washers were better.

I am guessing that it probably doesn't make THAT much difference between the two - would have been nice to keep them all nice and black but as long as it works I guess there is no issue.

Hoping to have them under the rocker studs in the next few days!

Are you guys using the stock length push rods? That was my other concern. I have the Manley one piece stock length rods but am worried they might be too long.

Anyone?

 

[syclone0209]

Re: will 1.6roller rocker.

i think there are a lot of factors to that. you want to get a pushrod length checker and check the installed height and geometry of the valvetrain. i think the cam, block decking, head gasket and everything com into play with that.