Recent content by Sean Krupa

Dig, My brother use to print out the messages for me when I bought the Ty and I think I didn't have a computer at the time. I use to look forward to reading the posts every week until I got my computer. He did this for me for many months. Now my son Sean Krupa owns the Ty. Rick Krupa AKA RKKustom

Looks nice and clean. Great job here is...

Bob, whats the Setup? I see Twin Turbos in your pic?

windshield wipers? What that?

This is one of those things that you take the plunge and never look back.You won't regret it.

I run -8 feed -6 Return lines. Dual 340 pumps. Used to run 120lbers but wanted extra room for future so I moved up to 160s. I also maxed a Single Walbro 450 pump running mid 10s. Now I'm 10.2 Best so have plenty of fuel now.

Yes, everything works. Holley has nothing to do with Fuel, Oil Pressure, Voltage, Speedo gauges. Holley is just for engine/trans control. Tuck away or Remove stock and install New. Thats it. I run Holley Injectors (160lb) on E85.

Yes Sir. All there is to it. I can hook you up with Part numbers and a reputable dealer to get it through for a great price!

Nice runs! Sounds like a 12.0 truck in the 1/4! You should be in the 1.6 range for 60' I would think are you pushing through the brakes or just not launching with even boost? I would agree to turn the wastegate rod out a tad, but that possibly will increase Lag. Either way good job, try turning...

I would get the Stefs Pan. I dealt with this when I built my motor. Got a RPM pan and no where near close to fitting properly if at all. Returned it and got Stefs and was mint! Was a little long on wait but worth it. Everyone else thats built a motor recently that upgraded their pan went Stefs...

^^^^ Stock Gauges work just fine. Nothing gets removed that has to deal with the gauges. You simply Tap in the C101 connector for Tach signal from Holley.

Great job. Keep up the good work.

Yep my little white 2014 EVO that I recently acquired for a daily is a rocket ship

Keep up the good work.

Please PM me if you have a front facing Renz sheet metal intake you are willing to part with. Thank You, Sean