My DM file...what do you think?

asrnj77

..hard to swallow
Re: My DM file...what do you think?

Is the link working? Can somebody take a look and gimme a hand? Thanks!
 

WyoSyclone

Active member
Re: My DM file...what do you think?

I clicked on it and it says 'no files or folders found'..... something must have happened during your upload.
 

turbodig

Active member
Re: My DM file...what do you think?

File worked for me.

There's not enough data in there to read anything useful.

One thing I did notice is that your intercooler isn't really working.... 135 deg temps at part throttle/idle.

Do the standard stuff if you haven't already... check the ic pump, make sure there's no air in the system, etc.
 

asrnj77

..hard to swallow
Re: My DM file...what do you think?

Thanks! I do believe there is air in the system from when I routed the heater lines together. What's the best way to purge it?
 

cloneman315

Active member
Re: My DM file...what do you think?

here is what i found to work well,take off the top rad cap and fill it like you do a outdrive on a boat,from the bottom.Unscrew the petcock on the bottom place a hose over it and pump coolant or water till it pushes all the air out the top rad cap then tighten the petcok with the hose ON then pull the hose off.should be all good.You will hear the pump change tone when the air is gone.
 

turbodig

Active member
Re: My DM file...what do you think?

Thanks! I do believe there is air in the system from when I routed the heater lines together. What's the best way to purge it?

The engine coolant and IC coolant are separate systems... heater core bypass wouldn't affect it.

Still doesn't preclude air in the system, though.

Easy way to check - pull the connector on the IC relay, and short the middle terminal of the 3 along the side to the one that sits apart on the bottom. You should be able to hear the pump run with the engine off.
If you can't, you either have a blown fuse or a dead pump.

If it does run, take the IC cap off and see if there's any movement in the coolant. If there isn't, you likely have air, or a kinked hose someplace.

The bottom-up fill method will get the air out, or you can keep filling/squeezing hoses/filling until the air is gone.

If someone has replaced the pump previously, make sure that the inlet to the pump has a hose to it that is gravity-fed... making the suction side suck water uphill is a good way to get air pockets.
 

asrnj77

..hard to swallow
Re: My DM file...what do you think?

So I made some basic maintenance stuff...new cap/rotor, taylor wires, UR6 plugs, rewired intercooler pump, new heater core, engine tie down, new harmonic balancer (old one cracked in half), timing reset, replace tcc solenoid
I know I need a new fp, and afpr but right now my dm file doesn't look so hot and this is after getting stuff up to speed (so I thought) This is the pitbull chip.Can you guys please take a look and tell me where to go from here? I've got an alky kit, afpr, fp, and getting the wb02 but I want to know why I can't get it running right before I make these expensive mods. Thanks for the input...I learn more each day :tup:

Datamaster file as of yesterday...
http://www.mediafire.com/file/gzmmfujkzgo/3BAR_new_turbo_2.uni
 
Last edited:
Top