Check out Diacom runs of a truck that needs a bad tune up

turbodig

Active member
Re: Check out Diacom runs of a truck that needs a bad tune up

You can open them with DM too, FWIW.

You've got a fuel problem, among other things.

It's an aftermarket chip of some kind, hard to tell which.

If it's a 2 bar chip, you're not getting much boost. If it's a 3 bar, you're probably getting a bit too much in third gear. Hard to tell what bin it is from this data.

I wouldn't drive it much either until the fuel thing gets straightened out.

later,
 

tnsyty

Active member
Re: Check out Diacom runs of a truck that needs a bad tune up

It needs a tune bad.. I have the ATR double pump, I am running 50lb injectors with the ultimate v3 and 3 bar map. It over boosts in 3rd gear and I have to let out of it every time. I want an E boost controller. What is the base FP supposed to be on a ultimate 50lb setup? I generally drive it to work once a month or to car shows and just don't get on it. It has never been teh same since I started modding it. I only have small mods.
 

ZavzTy547

Senior Member
Re: Check out Diacom runs of a truck that needs a bad tune up

tnsyty said:
It needs a tune bad.. I have the ATR double pump, I am running 50lb injectors with the ultimate v3 and 3 bar map. It over boosts in 3rd gear and I have to let out of it every time. I want an E boost controller. What is the base FP supposed to be on a ultimate 50lb setup? I generally drive it to work once a month or to car shows and just don't get on it. It has never been teh same since I started modding it. I only have small mods.

MALF 13: O2 Failor
Mat temps are a little high in the 190's.
 

tnsyty

Active member
Re: Check out Diacom runs of a truck that needs a bad tune up

Jimmy noticed out in KC that my narrow band A/F didn't cycle like they usually do when at part throttle a couple of years ago. It took it a year to actually throw a code. I am going to replace my I/C pump too. I used to always have my intake temps in the 120's with just it being hard wired. I am going to do a new distributor,plugs,wires,cap,rotor, I/C pump, Going to try to clean up some of the grounds also. If this doesn't get it worked out, I may be getting out of the syty scene.
 
Top