Wont Start - Fuel or Ignition?

WyoSyclone

Active member
Re: Wont Start - Fuel or Ignition?

Might want to get a stethoscope (or build one) and see if you've got an injector stuck open... if one isn't ticking like the rest that could be cause of it running rich.
 

Ryan

Member
Re: Wont Start - Fuel or Ignition?

Rob, all the plugs seem the same wet and black. I will check for a stuck injector though next chance I get.

As of now the truck is running on its own. Been fighting it most the afternoon. I swapped ECM and TPS and found a vacuum leak under the throttle body that goes to the egt.

It idles and responds to throttle but it is very rich with any throttle with plumes of black smoke. The fuel pressure is almost constantly at 41-42. During idle it will start to hesitate and the RPMs raise to catch it and it stays that way for about another 30 seconds and does it again. I may need to adjust timing a little.
 

Trapper

New member
Re: Wont Start - Fuel or Ignition?

Ryan said:
Rob, all the plugs seem the same wet and black. I will check for a stuck injector though next chance I get.

As of now the truck is running on its own. Been fighting it most the afternoon. I swapped ECM and TPS and found a vacuum leak under the throttle body that goes to the egt.

It idles and responds to throttle but it is very rich with any throttle with plumes of black smoke. The fuel pressure is almost constantly at 41-42. During idle it will start to hesitate and the RPMs raise to catch it and it stays that way for about another 30 seconds and does it again. I may need to adjust timing a little.

This sounds like what mine is doing. But Im waiting on another PCM to rule that out.
 

twin74s

Member
Re: Wont Start - Fuel or Ignition?

pull the hose off the FPR and make sure the diaphram isnt leaking fuel into the hose.
 

turbodig

Active member
Re: Wont Start - Fuel or Ignition?

Ryan said:
Rob, all the plugs seem the same wet and black. I will check for a stuck injector though next chance I get.

As of now the truck is running on its own. Been fighting it most the afternoon. I swapped ECM and TPS and found a vacuum leak under the throttle body that goes to the egt.

It idles and responds to throttle but it is very rich with any throttle with plumes of black smoke. The fuel pressure is almost constantly at 41-42. During idle it will start to hesitate and the RPMs raise to catch it and it stays that way for about another 30 seconds and does it again. I may need to adjust timing a little.

Sounds like back-up fuel mode to me. (ie, chip is loose or ECM)

Also, is that FP with vacuum or without?
 

Tooky

Serious about performance
Re: Wont Start - Fuel or Ignition?

Get it on a scan tool (DataMaster) and post your datalog here when the engine is idling.
 

Ryan

Member
Re: Wont Start - Fuel or Ignition?

I pulled the hose on the FPR this morning and couldn't see any fuel leaking out of it.

That is the fuel pressure with the vacuum hose connected. I will go test without right now.
 

Ryan

Member
Re: Wont Start - Fuel or Ignition?

The truck won't start on the original ECM now. The one out of my other truck is the one that will start and idle rich. Must be a combination of joy on this one.

is 48 no vacuum too high?

I'm going to swap my coil pack back to the original one.
 

Trapper

New member
Re: Wont Start - Fuel or Ignition?

I can't remember waht it is on stock injectors but I know my 75s are on 42psi. Sonds to me coil or dissy now.. i changed my PCM and it really made a difference, but I need to change my oil first now.
 

Ryan

Member
Re: Wont Start - Fuel or Ignition?

I didn't get a chance to swap the coil yet. Took it for a drive and it was terrible. Died at stop. Idles better than ever but don't drive.

I'm going to do the coil then I'll see if this reman dist/mod are bad.
 

Ryan

Member
Re: Wont Start - Fuel or Ignition?

Tooky said:
Get it on a scan tool (DataMaster) and post your datalog here when the engine is idling.

I have a cable on the way. Soon as I get it I'll post the log.

Thanks for everyone's help so far.
 

WyoSyclone

Active member
Re: Wont Start - Fuel or Ignition?

Well, STerm shows fuel being pulled the second it goes into Closed Loop.... the thing is running really cool... only gets up to like 76 degrees or so... does this seem right?? If the engine felt hot, or you know it was warmer than this, get a new temp sender as it will affect how the ECM handles fueling.
If the temp seems right, get it up over 160 degrees F and do another log.
It is running way too rich at startup... I've never seen mine richer than 12.9 at a cold start...
Hmmmm......
 

Tooky

Serious about performance
Re: Wont Start - Fuel or Ignition?

Hey Ryan, I took a look at the file. The datalog supports what you said about going way rich when you rev the engine at idle. The weird thing is, looking around Record #1416, after you rev the engine and it goes rich, it suddenly goes full lean (0-13mv O2, which means virtually a total lack of fuel) and stays this lean, and a few seconds later the engine RPM stumbles and dies. That seems very strange and significant to me, but I'm not sure what to make of it exactly. I guess the unanswered questions are #1. Why does it run so rich when you rev it? and #2. Why does it go lean and die afterwards?

Everything else looked OK except your IAC (idle air controler) counts were high. You said this happens on a cold start. By chance, are you disconnecting power to your battery when you store the truck? Normally I would think the truck should "learn" your idle position so it can remember it between starts. It almost seems like yours is starting from scratch but there's not enough data in the log to be 100% certain. I did notice when you start it, it's revving to ~2000 RPM and staying there for a while, that doesnt seem normal and supports my theory of a battery-disconnect fresh-start.

Are you sure the truck is really fully stock? Does it have stock, Bosch red-plastic-top fuel injectors?

MadPSI mentioned this in Post #2, but I want to make sure you're aware - you absolutely CANNOT run a 3 Bar MAP on any kind of stock chip.
 

Ryan

Member
Re: Wont Start - Fuel or Ignition?

The log I posted could have been from a start after a pulled ECMB or battery.

I pulled the MAP sensor and the truck idles good and continues to idle fine when I'm in drive. I took it around the block and it will idle fine, any gas and of course it starts to break up.

I put another 2 bar map on it and it does the same thing. Barely idles but idles fine with it unplugged. I checked the voltage on both MAPs and they were around 2.1 with engine off and key to on.

This one is starting to make me crazy.
 

Ryan

Member
Re: Wont Start - Fuel or Ignition?

The truck was definitely stock up to this point. The injectors are all red top clickers.

One of the only sensors I haven't replaced yet is the knock sensor. What effect is that sensor in this scenario? Unplugging the knock sensor to test have any effect?
 

dogboy

uk typhoon
Re: Wont Start - Fuel or Ignition?

now having the same trouble with mine after removing
charge cooler to replace a leaking pipe
 

Ryan

Member
Re: Wont Start - Fuel or Ignition?

Yeah I'm still banging my head about this one. I need to try a third ECM and MAP.
 
Top