20g question

[VinPecora]

does this universal 20g with the 10cm bolt right up to our trucks??

http://www.hahnracecraft.com/auto/Super 20G Universal.htm


Does anyone know where to get a 10cm or a 12cm cheap, or a place that wil do a cheap rebuild. thanks Vin

 

[SyTyJedi]

12cm are hard to find IIRC, or is it the 10cm? Either way, you will need to do a bit of tuning since the housing swap will change your fueling needs in certain areas.

I decided a long time ago that dealing with Mitsu turbos was a waste of time. Garrett, ITS, PTE are the only way to go.

 

[sy538]

http://www.syty.net/phpBB2/viewtopic.php?t=34617&highlight=20g
http://www.syty.net/phpBB2/viewtopic.php?t=33146&postdays=0&postorder=asc&highlight=20g&start=0

i guess they have made some in the past that bolt on but i havent found out if the universal 1s will bolt on or not.


sytyjedi

what makes you say that mitubishi turbos are a waste of time, is it just that they dont make 1 big enough? what if your goals are 11.9s (within what a 20g can do)?

 

[SyTyJedi]

sytyjedi

what makes you say that mitubishi turbos are a waste of time, is it just that they dont make 1 big enough? what if your goals are 11.9s (within what a 20g can do)?

Not as reliable (bearings replaced often in some applications)
Have to run more boost to make same HP
Expensive

A 20g can do 11.9s, but a RPM/PTE kit can do it easier.

Just my personal preference. There are tons of ways to get to 11.9s (or any other goal)