3 Bar and additional connector

SEL777

One of 101
So I'm planning to purchase a 3 BAR MAP and GM Parts says "
The old 16040749 part number has changed to this 2nd design and will require using a new connector 15305891 when replacing the first design sensor with the new 2nd design map sensor". It also says something about the TT/A. Do I need this part and the 3 BAR??
 

SY2932

Administrator
Re: 3 Bar and additional connector

Try the NEW part number and see what you get:
IMG_0250.sized.jpg

"MAP sensors, stock 2 bar on left (orange/red connector) #16009886 and 3 bar on right (black connector) old number is #16040749 new # is #12223861."
 

SEL777

One of 101
Re: 3 Bar and additional connector

This is the NEW number. So if anyone has purchased this 12223861 p/n and it works w/o the adapter?
 

berzerker

wookie
Re: 3 Bar and additional connector

the only thing i can think is that someone has changed gm weatherpacks . the map bar sensor is different from typical gm connections and has slits cut into sides of weatherpack pin covers on the side . which is different then the normal gm connectors. but the stock syty map sensor connector should have no problem connecting to another syty specific map sensor
 

SEL777

One of 101
Re: 3 Bar and additional connector

Sorry if I did not make my question clear. I'll try it again. Using the new p/n 1222... GM Parts site site mentions you will need an additional connector ( so the new 3 bar and another connector). It mentions the TT/A so I think this additional connector is needed if you're replacing the TT/A with this newer version. If this is still not clear please look at the p/n on GM Parts.
 

PPI Typhoon

DIY Madman
Re: 3 Bar and additional connector

I remember when I bought mine, it said I need the connector. That damn connector is STILL sitting on my shelf after I found out I didn't need it. Damn thing plugged right in.

I'm not sure if that's the exact same part # though.
 

Sy-Clone

Boost Junkie
Re: 3 Bar and additional connector

PPI Typhoon said:
I remember when I bought mine, it said I need the connector. That damn connector is STILL sitting on my shelf after I found out I didn't need it. Damn thing plugged right in. I'm not sure if that's the exact same part # though.
Wanna sell me the connector? I bought the new 3 bar map sensor and don't have the connector. PEACE>Tony
 
Top