I have a stock Sy so far, but i bought a 3-bar MAP sensor b/c i was going to get the STG chip. So here is my question:
I installed the 3-bar MAP on my truck and it ran like crap, i put my stock 2-bar MAP back and it run fine. Have anyone else had the same problem? I assume that the STG chip is calibrated for a 3-bar MAP, correct me if i'm wrong? The part # on my new MAP is 16040749.
I'm having a bunch of mods in my garage that is going on my truck as soon as i get some time over (new 20G is one of them).
Preciate any info, thanks.
I installed the 3-bar MAP on my truck and it ran like crap, i put my stock 2-bar MAP back and it run fine. Have anyone else had the same problem? I assume that the STG chip is calibrated for a 3-bar MAP, correct me if i'm wrong? The part # on my new MAP is 16040749.
I'm having a bunch of mods in my garage that is going on my truck as soon as i get some time over (new 20G is one of them).
Preciate any info, thanks.