4.04 kr

BMFB

Not to scale
Alright, first run on the new motor!

Not sure what to make of this, but I'm running code 59, and I did a data log. Now, I didnt really get into boost at all, maybe 8 psi at the most, and my afr looked fine on the gauge. Im being super careful cause the motors a bit different, mainly a bit high compression (around 8.7-8.9 to 1) but anyway upon looking at the logs, it would start to boost and hit 4.04 degrees of KR, and then slowly go away. It did that like, 6 times, exactly 4.04. According to my knock counter (which I know worked before, as it would climb crazy when knock happened) didnt record 1 knock, although it did start at something like 663 knocks.

any ideas?
 

JSM

Active member
Re: 4.04 kr

4.04 # shows up when you have an issue, wire unhooked, bad knock sensor, something goofy going on. Seen it a few times.
 

BMFB

Not to scale
Re: 4.04 kr

I was thinking about it, it seels like when i put it on I put some teflon tape on it for some reason...As i recal i first though It was going somewhere else then realized its going into the back of the block but left the tape on anyway...I'm not sure if it needs to be grounded, but...I bet it does. Could be the tape, I'll have to look at it...
 

BMFB

Not to scale
Re: 4.04 kr

i got a few minutes to look at it. first off...not easy to get to, second, it seems grounded, tricky to get a light down there but i did it without hitting anything else. the clip that retains the wire was spinny and kinda loose like normal, although it did pop while i was playing and pushing it a bit. Ill have to check for an improvement tomorrow, as the lap top is dead. it only hits 4.04 when giving it gas, never just idling...not sure what that means...
 

BMFB

Not to scale
Re: 4.04 kr

I have repaired this issue, the connector was slightly corroded, it would only throw 4.04KR under accel. just thought i'd share
 
Top