422 Cam and Emissions

PPI Typhoon

DIY Madman
So I am getting close to having the DP and exhaust done, which will conclude my mock-up of the turbo, A2A, radiator, intake, etc.

I'm starting to pick up parts for the motor. I just got my new Vortec heads from a fellow board member, have the block and crank. Need to start looking at more internals. I'm thinking of the 422 cam, but have questions.

Is the driveability ok?? And would it interfere with emissions?? Since we have no AWD dynos in AZ, there is only an idle test.

If it would be a problem, I'd go with the 412, but I'm looking for that slightly meaner idle as well as as much performance that I can get.

Thanks
Ok.gif
 

crashing_sux

Blow Me?
Re: 422 Cam and Emissions

I had no problem with emissions and I'm running a 422 with Vortecs. I did drop the fuel pressure down a bunch but I'm not sure I actually had to do that, passed with flying colors the first time through, just didn't want to risk having to go through twice. Got out of the test, drove one parking lot down and raised the pressure back up. Drivability is great.
 

VermontTy

Support Our Troops
Re: 422 Cam and Emissions

crashing_sux said:
what's the rest of your build like? I've got a 412 w/vortecs on the way. Wondering what the difference in the 412 and 422 would yield....
 

crashing_sux

Blow Me?
Re: 422 Cam and Emissions

I have no idea what the difference would be, but I'm running Headers (don't know what brand), PTE 68, 72#'ers, 3" exhaust, muffler but no cat, Eagle rods, JE pistons, ported heads. Thinks that about covers it.
 

sean

Member
Re: 422 Cam and Emissions

crashing sux- did you have to get a chip for the 422? what chip are you running?
 

crashing_sux

Blow Me?
Re: 422 Cam and Emissions

Someone on the board can set you up for a few hundred bucks, just throw a post in the tuning forum. You don't need a chip per se, but you need something, for a while I was running a gen 6 dfi but I'm happier now that I've switched back to the stock ecm.
 

RAACCR

Member
Re: 422 Cam and Emissions

I passed Florida's sniffer (back when we still had it) with a 222* cam and a gutted cat...just make sure the motor is fully warmed up, drop the fuel pressure until it runs like crap and bump up the idle speed via the torx fitting on the TB. If all else fails, run the gas low and mix in about 10% denatured alcohol into the tank. (If you've got a cat, it will pass no problem.)
 

ghettosled

SYTY SUPERSTORE
Re: 422 Cam and Emissions

hey rob, were you the one who plumbed the scuba tank into the exhaust and pumped oxygen into it for emissions?
 

crashing_sux

Blow Me?
Re: 422 Cam and Emissions

The stock ecm, not the stock bin. Do a search, plenty of people here who can help you out with bins if you go that route, it'll probably cost you a few bucks for their time though.
 

RAACCR

Member
Re: 422 Cam and Emissions

ghettosled said:
hey rob, were you the one who plumbed the scuba tank into the exhaust and pumped oxygen into it for emissions?

Never had to use that trick on any of my Syclones, but we got a few pretty radical mustangs and a turbo'd 'Vette through emissions with the scuba tank.
 
Top