A/A vs stock IC - spool up wise

Falco

Donating Member
We were talking a lot about the A/A IC's avaiable around, lately. However I can't recall anybody comparing them spool up wise. Does anybody have hard data on this? Is there any significant difference between a stock setup with all the tricks (bell mouthed stuff) and RPM's A/A kit for example?

Later,
 

Buster

New member
Way back (last year) when I was running the dinky 63 and the 2800 stall, I didn't notice much difference going from the stocker to the KB with revised piping, but when I went to the big system (CAS dual core) I did notice some lag.

Now I'm running a better combo, 3500 stall and the dinky 63, I could probably run 5 inch piping to the bed and back without a problem, basically as long as your combos decent you'll be fine, plus you have access to table 61 in promgrammer for any minor tweaking.

NOW, I'm still looking for some damn numbers on the RPM kit, for whatever reason no one will give 'em up. I'm mean just a simple 0-100 mph log would be nice to look at, even if it's a stocker, I don't care.
 
from what i can figure, spool up time should be exactly the same, the only difference is that there is lag from the increased amount of air in the intake. It takes longer to compress a larger volume of air. So naturally the larger the intercooler(and amount of piping) the more lag there is. But there is almost always a noticeable difference in the delay.
 

AXXE

Member
I would like to see the temp numbers also. There is a GP starting for A2A, but I still would like to see some data before spending $1000.
 

Buster

New member
If I see a decent log using the RPM kit, I'd be glad to send my money to Mike, he's a good vendor, but I need numbers first.
 

HighPerformanceTrucks

Lift & Shift Specialist
I'm keeping the air to water setup. As a matter of fact, I'm working with a company to produce a more efficient upper ic to handle the increase cfm.

Adam Auerbach
Sy #2419
 
Top