a/f ratio during AE

leroy

Donating Member
If you are using wide band, what kind of air/fuel ratio are you guys seeing during acceleration enrichment?

I'm fighting a small stumble......can't seem to get it quite right. Sometimes it's hard to decide where to make changes....the VE table or AE tables.

Any advice appreciated.

Jim
 

smeagol

Active member
The way I go about it (this seems right to me, not sure if it's correct) is to tune the VE table at static conditions, throttle/MAP not changing. Any changes in the current running conditions would require AE/DE/PE 'interference' in the algorithms, so those should be the tables used for tuning such dynamic conditions.

So for your lower rpm/lower map tuning, i'd do cruising around town in 2nd/3rd gear, 10-40% throttle. Use integrator values to tune the whole map best you can (if on stock computer). Then start your AE/DE fuel tuning. This works very well for me, the real difficulty is deciding which AE tables to change, and how much. For AE fueling, whenever you hit the throttle and require fuel, your MAP, TPS and RPM all change at once, yet there are individual tables to change for each of those...
 

leroy

Donating Member
Good points Brian. Another "interference" factor is temperature.

I am seeing a/f ratios dip to 8.5 or 9:1 in AE. I don't know if this is normal, since I got the wideband after I installed the cam, injectors, etc. I was curious what others are seeing.

The stumble is very subtle and I am probably the only one to notice it. It seems to occur at lower rpms, so I may try some changes the ae rpm multiplier table.

Thanks.
 

smeagol

Active member
I was having a similar problem with the 50s in Jerry's Sy. The AE was great for the longest time, then i started screwing with things, left it alone for a while, and had a horrible stumble. Changed all sorts of hardware, go back to the cal and solved it with a single chip burn. Seems I was dumping in *too* much fuel at AE.

You are using the 50s right? The AE tables i used on the cam/heads truck seem to work best so far for the stock motor ones as well. The only issue we've seen with these tables so far is that when you rev it in P/N there is a bit of a stumble. While driving they are great. I'll sacrifice the neutral stumble for good drivability for now ;)

If you want to see those tables, let me know.
 

leroy

Donating Member
I'm using the 55# injectors. It seems to need a cal quite different from the 50's. I'm sure linearity and the p&h are factors. All things considered, the tuning is going well, but still have quite a bit of work to do.

Does the 8.5 dip sound normal?

Jim
 
Top