ALDL test

gnjeff.t

New member
I have a 93 Ty, and am having trouble getting any type of scan tool to connect. I have a DATAMASTER and a friend (how ownes a shop) tried his handheld scantool, neither of which was able to connect or retrieve data. I have tried MANY times to get the DATAMASTER to connect, messing with the COM ports and such, non of which worked. That is why I contacted my friend to try his scantool.

The Ty has an Ultimate Chip in it. I did not install the chip. Could the installer have done something to prevent the data being sent to the ALDL?

Is there a way to test the connection between the ALDL port and the ECM?

What are the different pins in the ALDL used for?

Any and all assistance with this problem will be greatly appreciated.

Thanks to all in advance, Jeff.
 

gnjeff.t

New member
Re: ALDL test

O.K. I have taken the ECM and out nothing seems out of place. There are two connections that are not connected to anything. One is a single white wire, the connection has "ped 5" on it. The other one is a two wire connection with orange/black colored wires. The connection on this one has "ped 10" on it, and where the wires go into the connection the wires are labeled A and B. Orange for A and black for B. They both seem to be factory connections. Are these supposed to be connected to something? I could not find the other ends for these to connect to. The do not connect to each other.
 

Big Mike

New member
Re: ALDL test

Pick up one of these tools or use a paper clip to read your codes, Check engine light should blink with tool in place and key on.
p_070214_06771.jpg
Your buddy with the shop should know how to read codes off an OBD1 setup with a paper clip.
 

gnjeff.t

New member
Re: ALDL test

I do not need to read the codes, I need to find out why the data from the ECM is not being picked up at the ALDL. I am trying to get information on testing the connection between the ALDL and the ECM. I have had some wiring issues with the truck last spring, were the "check engine" light was wired to light the "check gauges" light. I don't know if there are other mis-wired wires.
 
Re: ALDL test

I think there's a diagram of the aldl port on sportmachines.com I'd start with that and a DMM to see if you're getting power and ground from the correct pins at the connector. Too bad DaveP is on a road trip. This is definitely something needing his expertiese.
 

Big Mike

New member
Re: ALDL test

I suggest you find a wiring diagram and get to work then, tracking down all your wires will be fun and could take hours if not days or weeks. I hope your purchase price reflected all the problems with your truck. Good Luck.
 

JSM

Active member
Re: ALDL test

I suspect you have a laptop setup issue in how your setting up the com port, or the cable you have is wrong.

Our ecm's are not easy to talk to stock.
 
Top