alky control wiring question

[Sean Donn]

I am wiring an alky control kit (used) using the tutorial posted on here. I am almost done except for 3 wires coming from the pac box. One is green (map sensor) but does not have the plug pictured in the tutorial and the other two are grey and purple, respectively. Could someone tell me where exactly these connect? Thank you

 

[Boostin 92]

Re: alky control wiring question

I did mind and didn't use them

 

[dgoodhue]

Re: alky control wiring question

Purple is not normally used. It reduces the pump speed for applications like a trans brake or line lock operation.

For some reason I think gray wiring going to the controller was also not used but I can't remember why.

 

[Don W.]

Re: alky control wiring question

If it's not to late I'll look at my wiring diag later and get back to ya.

 

[Sean Donn]

Re: alky control wiring question

not too late. I'd appreciate it

 

[Quickstop [UK]]

Re: alky control wiring question

Ask Bubba!

 

[Don W.]

Re: alky control wiring question

I am wiring an alky control kit (used) using the tutorial posted on here. I am almost done except for 3 wires coming from the pac box. One is green (map sensor) but does not have the plug pictured in the tutorial and the other two are grey and purple, respectively. Could someone tell me where exactly these connect? Thank you

Wires from PAC

1) Grey - not connected
2) Purple (Violet) - not connected
3) Orange/Brown - turn-on LED
4) Green - MAP
5) Black - ground
6) Red - ign

His instructions are somewhat unclear but that's what I come up with. LMK if you need more or this doesn't make sense.

 

[Sean Donn]

Re: alky control wiring question

Bubba said to cut the green wire and then remove the map sensor all together. Bubba said I can then cut the rest of the wires at the source and put them on a shop bench to snap a picture of all the crap I just removed.

Jokes aside, thank you Don that is exactly what I needed for now. Once I wire the map sensor this weekend I will be finished.