Alky kit question.

[attackdog]

The other day, my alky kit (SMC) started spraying and I had to turn it off to make it stop. Everytime I would turn it back on, the "spray on" light would stay lit and it would spray at idle and any other speed. I had to disconnect the power and ground from the control box for awhile to get it to reset itself. Is this normal or is there something wrong? Thanks.
-Deano

 

[blk00z28]

Re: Alky kit question.

I havent had that problem. I believe there is a little reset button on the side of the box isnt there? Maybe your purge button got stuck on somehow, or had dirt in it, check that out first before anything.

If you hook it back up again and it keeps doing it, e-mail them.

phone or fax: (270) 522-9376
email: schlupsa31@mchsi.com

 

[SeattleSy#1255]

Re: Alky kit question.

i have had the same prob mostly, however my light will stay on but its not spraying va DM saying temps aren't dropping and idle doesn't choke out. I never could figure out why that happens and since its only the light, I never tried to fix it.

SMC is a great to deal with and if you contact them, you will likely get a reply or some help.

 

[blk00z28]

Re: Alky kit question.

The only problems I've had thus far are the pump going out, and my "low" light stays on all the time. (Dont know why.. :dunno: )

I hope I dont get this problem though. Thats for sure, lol.

 

[SeattleSy#1255]

Re: Alky kit question.

The only problems I've had thus far are the pump going out, and my "low" light stays on all the time. (Dont know why.. :dunno: )

I hope I dont get this problem though. Thats for sure, lol.

well, that is essentially th eproblem I have...a light stays one...the pump never has.

 

[Gmoney]

Re: Alky kit question.

This happened to me but I have Razor's alky kit. I went out one morning, tried starting it but it sounded like it was flooded. It was because the MAP sensor went wacky and told the pump it was in full boost whenever I turned the key on, so....it pumped that whole tank of alky into the motor and thats why it wouldn't start and sounded like it was flooded. I replaced the MAP sensor and all was good.