Another boost controller question

nello

Active member
I've been searching for answers and between broken links and a mix of information I have no real resolution to my problem.

I have the blitzIII 90% installed. Now what to do with the stock solonoid? I've got a rebuilt motor, upgraded Stage1 turbo, internal WG, catless exhaust, stock inj, 2bar, and factory chip.

Now if the stock boost solonoid is removed how does the ECM know the truck is boosted anymore? I'm just a tad worried about running lean being the ECM is no longer in control of boost. Or will the ECM just operate normally off of TPS, MPH??

With the blitz installed is it safe to run? Can a stock truck go this route? thx
 

1madgumby

New member
Re: Another boost controller question

That is what your Blitz contoller does in place of the stock one. Alot of people just yank them off. Just start at A low boost setting & datamaster it to see if you running lean, just watch you knock counts, 0.0 is perfect. With your stock chip & that 2 bar will be your biggist down fall. Need to get A custom 3 bar chip & A 3 bar map. Talk to sy sy2921 on the board. he is pretty good with chips & he can burn you A couple 3 bar ones.
 

sy#2921

BAMF
Re: Another boost controller question

Datalogging the truck will be your friend to make sure nothing happens to that motor. With a stock cal and a larger turbo the bin needs to be change even in the non-boost normal driving areas.

With going to an aftermarket boost controller you will loose the safety of the stock controller and overboost situations. However if you pay attention to what is going on with the truck you will but almost as safe. Just take the stock controller out of the loop and keep it as backup. Start with the ID-III on a very low setting and go from there.

Do you have a wideband and datamaster or tunerpro? If you do not then I would get both before you think about messing with the truck
 

1madgumby

New member
Re: Another boost controller question

Just as he says. or put the stock turbo back on & leave it. That is what I would do, put with mine im in to deep for that now. Went from A stock computer to A F.A.S.T. system. AWSOME!!!
 

nello

Active member
Re: Another boost controller question

I finally got around to fully installing the blitz boost controller. I had a partial install because I couldn't get both my boost gauge and boost controller hooked up at the same time. So without a boost gauge i was flying blind...that's a no go.. Ordered a V-block from http://www.gofastgoods.com, problem solved. Took me forever to find that damn thing but totally worth the wait. I've got my boost controller, BOV, and boost gauge all working now.

After installing the V-block today I finished up the blitz and went for a test run. HOLY SH*T! What a difference! I set my "gain" to 50 and my "set" to 40 as a starting point (should give about 17-18psi) like I'd seen another member do. I was getting an instant 12psi at 30% tps. The truck just bolts. Can't wait to get the truck tuned and WOT this monster. She want's to go! :cheers:
 
Top