Another diy-wb question

BillC

New member
Howdy,

I finally finished my DIY-WB 02 sensor kit, and amazingly enough, it actually seems to work. However, I noticed that the heater circuit stays on, at least during the 3 minutes I tested it. Is the heater circuit supposed to stay on continuously, or should it shut off or cycle (between on and off) at some point? If it's supposed to shut off or cycle, how long should it take for that to happen? I looked in the documentation, and couldn't find a definitive answer.

Thanks,
Bill
 

BillC

New member
Well, since either no one knows or no one feels like telling us, I sent an email to Peter Gargano at TechEdge asking the same question. The answer is that the heater circuit stays on at all times, regulating voltage to ~10.3 volts and current to a max of 1.5 amps. Therefore, be careful about touching the heatsink after using the WBO2 for a while, it could be rather warm.
 

leroy

Donating Member
The heater circuit needs to be on all the time. The sensor can be damaged if run too long without the heater active.

My biggest problem now is what to do with all the wires. I've been running wires through the passenger door or window to the tailpipe and also under the hood for battery connections. I've found that you need a good power supply to get the best results. I originally thought I could power with a cigarette lighter adapter, but I also needed power for the inverter for the computer. I ended up hooking up a dedicated power outlet in my truck, but that doesn't solve the problem for other vehicles.

We ran it awhile on Zach's Syclone yesterday. It was just about impossible to get in and out on the passenger side with the emulator, wideband, laptop, inverter, voltmeter and wires.

Still getting organized.

Jim
 
Top