Another Motor Mount Option

denny

Active member
Re: Another Motor Mount Option

fyi - our motor is tilt down in the rear " 7-8 deg taper that allows the rear of the motor to sag "

RPM frame pad have this, Turbotime does not.

This maybe a minior thing but it cause other problems , like aftermarket headers and steering shaft clearance, aftermarket valve cover touchng the firewall..

Do it right !
 

BigBadSmoosh

Picking fights on I-65 since 2013
Re: Another Motor Mount Option

fyi - our motor is tilt down in the rear " 7-8 deg taper that allows the rear of the motor to sag "

RPM frame pad have this, Turbotime does not.

This maybe a minior thing but it cause other problems , like aftermarket headers and steering shaft clearance, aftermarket valve cover touchng the firewall..

Do it right !


odd, i have never had problems with the turbotime pads.. or their alignment.
 

warmpancakes

New member
Re: Another Motor Mount Option

I ran them for years on my V8 S10. When I pulled the engine I noticed that the rubber did stretch a bit and sag down but they were still in one piece and doing their job. Someday I'd like to fab up a set of these:

Nice%202_8%20motor%20mounts.jpg


Some guy on a S10 forum used to sell those. If I could only figure out where to buy those bushings the hard part would be done...


tHOSE ARE LEAF SPRING BUSHINGS, WITH A SMALLER id SLEEVE ENERGY SUSPENSION HAS ALL THE MEASUREMENTS FOR THEIR BUSHINGS
 
Top