Another truck

syclone58chevy

New member
Just picked up a really clean 92 gmc Sonoma pick up. I put one of my gta rims on it was considering making a Marlboro syclone clone. I have plenty of parts including a low mile 100 percent complete drive train minus front diff. This truck is also 2 wheel drive and I would leave it that way. I have black typhoon seats as well and would put my red belts from my saw blade syclone in it. Looking for feed back on my new project. Will post pics soon
 

Flyin Ryan

hated cuz he drives fords
Re: Another truck

I would just drive the truck personally.. I mean are you going to dump over 2 grand out of pocket for cladding? are you going to cut the roof up to make it t tops like a Marlboro? are you going to install a full roll down rear window like a Marlboro? paint it the lipstick red color? etc

You would never get your money back out of the truck that your going to sink in to it even if you weren't going for a Marlboro clone just a sy clone and if you did pull it off it's still 2 wheel drive with a quarter of the performance :)
 

Smkur50

SYTY Fleet owner
Re: Another truck

I would keep it nice and clean with a good LS 2wd setup..I bet if you made it a 6 speed you could get close to 30mpg hwy. Laways thought about doing this for a daily driver myself.
 

syclone58chevy

New member
Re: Another truck

Although I like the ls and six speed idea, I already have a complete low mile syclone motor minus the wire harness. I do have a 8.5 ten bolt rear end for it with 341 gears and it is posi.i would just need to pick a trans, then figure out if I would do coil overs like in my saw blade truck or cal tracs to make up for lack of 4 wheel drive(traction) I own my own muscle car restoration shop so fabricating roof and paint no big deal, just making time is.. Not really and investment ,just want to try something different. Thanks for input
 
Top