Hi SyTy fellas,
Did anyone had this problem before?
You know the front rubber fenders on our trucks. What happens when the rubber pieces connected to those rubber flares get just ribbed out by aging factor or heat stress....etc.
I took the whole rubber piece out and tried to glue those small nobs to the main unit, by using industrial rubber glue and strengthining the piece itself by Duct tape pieces on the side to hold it in place, but after connecting the main unit again, some pieces just came out and stayed just hanging there. I do not want to touch it at the moment because that will mean that I go through the same thing of gluing those pieces again.
Is there any solution for those little pieces that will stick them again like the original unit?
Many thanks in advanc for any suggestions,
Merry Christmas and a very happy new year
Khalid
Saudi SyTy
Did anyone had this problem before?
You know the front rubber fenders on our trucks. What happens when the rubber pieces connected to those rubber flares get just ribbed out by aging factor or heat stress....etc.
I took the whole rubber piece out and tried to glue those small nobs to the main unit, by using industrial rubber glue and strengthining the piece itself by Duct tape pieces on the side to hold it in place, but after connecting the main unit again, some pieces just came out and stayed just hanging there. I do not want to touch it at the moment because that will mean that I go through the same thing of gluing those pieces again.
Is there any solution for those little pieces that will stick them again like the original unit?
Many thanks in advanc for any suggestions,
Merry Christmas and a very happy new year
Khalid
Saudi SyTy